Errors; Warranty; New Tool Warranty - RAD Torque Systems MV-RAD 6 User Manual

8. Errors

In the case of a malfunction or a message for the user, different messages can be shown on the display.
These messages can be confirmed by pressing the "M" key. If certain errors appear on a regular basis,
please contact RAD Torque Systems, tel. +31 (0) 35 588 24 50.
ERRORS
Maintenance schedule / Wartung planen
/ Plan Maint
Fout toerental / Fehler Drehzahl / Impuls
Sensor
Fout Spanning / Fehler Spannung /
Error Voltage
The settings in the main menu are
displayed in red after a joint.
The message "Links / Left / Linksauf" is
displayed in red.

9. Warranty

9.1 New tool warranty

Any new tool branded with the RAD name and purchased from RAD Torque Systems B.V., or through one
of its authorized distributors or agents, is warranted to the original purchaser against defects in materials
and workmanship for a period of twelve (12) month from the date of delivery to the end user. This
guarantee is valid until fifteen (15) months after the original calibration date.
Furthermore, the warranty conditions determine that no warranty applies if:
1. The defect, wholly or partly, is due to unusual, inappropriate, improper or careless use of the product;
2. The defect, wholly or partly, is due to normal wear and tear or lack of proper maintenance;
3. The defect, wholly or partly, is due to unusual, is due to installation, assembly, modification and / or
repair by the customer or by third parties;
4. The product altered, modified, used or processed is;
5. The product is transferred to a third party;
6. RAD Torque Systems B.V. has obtained the product, wholly or partly, from a third party, and RAD
Torque Systems B.V. cannot claim compensation under warranty;
7. RAD Torque Systems B.V., in manufacturing of the product, has used raw materials, and suchlike on
the instructions of the customer;
8. The product has a small deviation in its quality, finishing, size, composition and suchlike, which is not
unusual in the industry or if the defect was technically unavoidable;
9. The customer has not fulfilled all obligations under the agreement promptly and correctly towards RAD
Torque Systems B.V.
Version 1.0 - June 2015
MEANING
More than 20,000 joints have been
performed. Carry out the maintenance.
The impulse sensor is defect.
The supply voltage does not correspond
to the specifications of the tool.
The last performed joint was not
tightened according to the setting.
Loosening is not possible.
User manual MV-RAD
SOLUTION
This indication can be confirmed by
pressing the "M" key. After this, the torque
wrench can be used again. If the service
interval is performed by RAD Torque
Systems B.V., the counter will be reset
and the message will not appear until
20,000 joints have been performed.
Contact RAD Torque Systems B.V., tel.
+31 (0) 35 588 24 50.
Check the supply voltage to which the
tool is connected.
Loosen the joint and repeat the tightening
process. Press the switch of the torque
wrench until it switches off automatically.
The joint that needs to be loosened is
tightened too much. To prevent damage
to the drive mechanism, the tool will
automatically switch off.
8