Floor Brush - Vaporetto ECO PRO 3000 Manual

dure here below when re-filling the generator
tank.
According to model, 'water out' is indicated by a
warning light (J), or by an audible alarm signal
from the machine, or on more basic models by
the exhaustion of the steam output.
When you have used up all the water in the
tank, proceed as follows:
• Switch off the machine at the generator on/off
switch (B).
• Press the steam request lever (3) on the
steam gun (2) or, if using the iron, the steam
request button (R) on the iron (Q) so as to
fully exhaust the steam supply from the tank.
• Switch OFF the accessory on/off switch (C).
• Disconnect the power supply cable (F) from
the mains.
• Unscrew anti-clockwise the patented safety
cap (A)
• Wait for a few minutes to allow the generator
tank to cool down.
• When cool proceed to carefully refill the tank
as described in paragraph 1 of the section
"Preparation for Use".
WARNING: Not complying with this proce-
dure can expose you to the risk of burns.
PRECAUTIONS FOR DELICATE
SURFACES
• Before treating leather, special fabrics and
wood surfaces, consult the manufacturer's in-
structions and always carry out a test on a
hidden part or on a sample of the material. Al-
low the steamed part to dry to make sure that
no changes in colour or deformations have
occurred.
• Please pay careful attention when cleaning
wooden and treated terracotta flooring as pro-
longed use of steam may damage the wax,
polish or colour of the surfaces to be cleaned.
We therefore recommend adjustment the
steam to minimum (if your appliance has
steam adjustment) and never direct the jet of
steam directly on the surface, but cover the
brush with a cloth. Do not keep spraying
steam in the same place.
For wooden surfaces (furniture, doors, etc.),
we recommend cleaning with a cloth which
has been steamed previously.
• Also on particularly delicate surfaces (e.g.
synthetic materials, lacquered surfaces etc.) it
VAPORETTO ECO PRO 3000
is recommended to always cover the brushes
with a cloth and to use steam to a minimum.
• If cleaning glass surfaces in particularly low
temperatures preheat the glass using the
hand gun from about 50 centimetres distance
from the surface to be cleaned.
• For care of your plants vaporise at a minimum
distance of 50 centimetres.
PRACTICAL ADVICE FOR THE
USE OF THE ACCESSORIES
STEAM GUN (2)
The steam gun can be used directly on all spots
requiring a stronger, closer treatment without
connecting the brushes. The more resistant the
stain, the closer you should hold the gun, the
steam pressure and temperature being higher at
the source. Always wipe with a dry cloth (or a sli-
ghtly abrasive sponge if the spot is a difficult one
to remove) after using the gun. Steam gun is
particularly efficient at:
• breaking down rug and carpet stains before
they are treated with the large brush;
• cleaning stainless steel surfaces, panes, mir-
rors, enamelled surfaces;
• cleaning hard-to-reach corners, such as
stairs, window sills, door posts;
• cleaning cooking top knobs, taps bases
• cleaning window shutters, heaters, car inte-
riors;
• spraying plants (from a distance);
• removing odours and creases from clothes.
To reach higher points, the steam gun can be
connected to one or both extension tubes.

FLOOR BRUSH (8)

• To clean floors, attach a dry, clean cloth to the
brush and pass it moving from top to bottom
without pressing. When one side is dirty, turn
the cloth.
• Use the brush without cloth over dirty or sca-
led areas and over tile joints making lateral
movements to lift the dirt.
• For vertical washable surfaces or upholstery
and ceilings, cover the brush with a dry cloth
and proceed as for the floor.
• On all types of synthetic or wool floor/wall car-
pets, as well as area rugs, Vaporetto ensures
maximum hygiene, giving them back their ori-
ginal appearance and brightening up the co-
lours. Run the brush without cloth over the
21