Specifications - Makita HR2800 Instruction Manual

ENGLISH
1-1. Switch trigger
2-1. Lamp
3-1. Reversing switch lever
4-1. Quick change chuck for SDS-plus
4-2. Change cover line
4-3. Change cover
5-1. Spindle
5-2. Quick change drill chuck
5-3. Change cover line
5-4. Change cover
6-1. Action mode changing knob
7-1. Action mode changing knob
8-1. Action mode changing knob
9-1. Action mode changing knob

SPECIFICATIONS

Concrete
Capacities
No load speed (min
Blows per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Explanation of general view
10-1. Grip base
10-2. Side grip
10-3. Teeth
10-4. Protrusion
11-1. Bit shank
11-2. Bit grease
12-1. Bit
12-2. Chuck cover
13-1. Bit
13-2. Chuck cover
14-1. Action mode changing knob
15-1. Action mode changing knob
16-1. Depth gauge
17-1. Dust cup
Model
Tungsten-carbide tipped bit
Core bit
Diamond core bit (dry type)
Steel
Wood
-1
)
Overall length
Net weight
Safety class
equipment and
environmentally compatible
HR2800/HR2810
314 mm
3.2 kg
END201-3
For Model HR2800
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone.
It is also suitable for drilling without impact in wood,
metal, ceramic and plastic.
For Model HR2810, HR2810T, HR2811F, HR2811FT
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone as well as for chiselling work.
It is also suitable for drilling without impact in wood,
metal, ceramic and plastic.
its
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
4
19-1. Blow-out bulb
21-1. Chuck adapter
21-2. Keyless drill chuck
22-1. Quick change chuck for SDS-plus
22-2. Change cover line
22-3. Change cover
23-1. Spindle
23-2. Quick change drill chuck
23-3. Change cover line
23-4. Change cover
24-1. Sleeve
24-2. Ring
24-3. Quick change drill chuck
HR2810T HR2811F
28 mm
80 mm
80 mm
13 mm
32 mm
0 - 1,100
0 - 4,500
339 mm 320 mm
3.3 kg 3.2 kg
/II
HR2811FT
345 mm
3.4 kg
ENE042-1
ENE043-1
ENF002-1