Memory - Medisana MTC Instruction Manual

51139_MTC_West_aktual.qxd:Blutdruckmessgerät
GB
4 Operation / 5 Memory
4.3
Taking blood
pressure readings
4.4
Switching off
the unit

5 Memory

5.1
Displaying
stored results
20
1. Switch the unit on by pressing the START button
2. If the START button
characters are shown (display test). This test is used to check that the dis-
play is indicating properly and in full. The display shows the values from the
previous measurement. Information will be given in the language set if the
language function is switched on. If no measurement has been taken,
zeroes will appear next to the date and time.
3. The unit is ready for measurement, the number 0 is displayed, the start of
measurement will be announced if the language function is switched on.
It automatically inflates the cuff slowly in order to measure your blood pres-
sure. The pressure on the display changes continuously during the time it
continues to inflate.
4. The unit inflates the cuff until sufficient pressure has built up for a measu-
rement. Then the unit slowly releases air from the cuff and carries out the
measurement.
5. When the measurement is finished, the cuff is deflated completely. The
systolic and diastolic blood pressure and the pulse value with the pulse
symbol appear on the display
flashes next to the relevant coloured bar depending on the WHO blood
pressure classification (see page 16). The measured results will be an-
nounced in the language set if the language function is switched on.
6. The measured values are stored automatically. Up to 60 measured values
with date and time may be stored in the memory.
The unit has an automatic switch-off function. The unit switches off automati-
cally after about 1 minute, if no button is pressed during this period.
The unit may also be switched off using the START button
The time and the date are constantly shown in the display.
The memory of your blood pressure monitor will hold up to 60 measurements
(blood pressure and pulse with time and date). Press the MEM button
call up the saved measured values. The saved data will appear on the display.
Initially the number of memory locations occupied will appear then the values
of the most recently saved measurement including the flashing blood pressure
indicator will be displayed.
If the voice function has been activated, the device speaks the memory
location number, together with the saved blood pressure and pulse values and
the blood pressure assessment as per the scale in the World Health Organisa-
tion guidelines (see pg. 16).
Repeatedly pressing the MEM button
measured previously. In memory recall mode, the unit will switch off auto-
matically after approx. 120 seconds if the last entry has been reached and no
button is pressed. Memory recall mode can be exited at any time by pressing
the START button , which will also switch the unit off.
07.12.2010 12:03 Uhr
.
is pressed, a beep is heard and all display
. The blood pressure indicator
displays the respective values
Seite 20
.
to