Making The Connections; Placement Of Speakers - Panasonic SC-PM250 Owner's Manual

Making the connections

Connect the AC power supply cord only after all the other
connections have been made.
3
1
Connect the FM indoor antenna.
Place the antenna where reception is best.
2
Connect the speakers.
A
Red
Be careful not to cross
(short-circuit) or reverse
the polarity of the
speaker wires as doing
so may damage the
speakers.
3
Connect the AC power supply cord.
To household
AC outlet
Do not use an AC power supply cord from other
equipment.
Conserving power
The system consumes a small amount of power
(Z"Specifications") when it is in standby mode.
Disconnect the power supply if you do not use the
system.
Some settings will be lost after you disconnect the
system. You have to set them again.
1
2
SPEAKERS
(SB-PM02)
Adhesive tape
(not supplied)
B
Black

Placement of speakers

The left and right speakers are the same.
You cannot remove the net of the speakers.
Use only the supplied speakers.
You can cause damage to the system and decrease the
sound quality if you use other speakers.
Note:
•
Keep your speakers more than 10 mm (
unit for ventilation.
•
Put the speakers on a flat safe surface.
•
These speakers do not have magnetic shielding. Do not put
them near TVs, PCs or other equipment easily influenced
by magnetism.
•
When you play at high levels for a long period, it can cause
damage to the speakers and decrease the life of the
speakers.
• Decrease the volume in these conditions to prevent
damage:
– When the sound is distorted.
– When you adjust the sound quality.
CAUTION!
•
Use the speakers only with the recommended system.
If not, you can cause damage to the amplifier and
speakers and can cause a fire. Consult an approved
service personnel if damage occurs or if there is a
sudden apparent change in performance.
•
Do the procedures included in these instructions
when you attach the speakers.
13
") from the main
32
5