Table of Contents
Advertisement
TABLE OF CONTENTS
SECTION 1. GENERAL INFORMATION ................................................................................ 2
SECTION 2. MEETING CODES ............................................................................................. 3
SECTION 3. DETERMINING CONDENSER LOCATION ....................................................... 3
SECTION 4. REFRIGERANT PIPING CONNECTIONS ......................................................... 4
SECTION 5. ELECTRICAL CONNECTION ............................................................................ 5
SECTION 6. REFRIGERANT CHARGE.................................................................................. 6
SECTION 7. CHECKOUT PROCEDURE................................................................................ 7
SECTION 8. MAINTENANCE ................................................................................................. 7
SECTION 9. TROUBLE-SHOOTING CHART ......................................................................... 9
SECTION 1. GENERAL
INFORMATION
These instructions cover the installation of the following split
system 13 SEER condensing unit.
illustrated in Figure 1. Physical and electrical specifications
are provided in Table 2.
Read this manual and any instructions packaged with
separate equipment required to make up the system prior to
installation.
The outside unit is designed to be placed alongside or at
the back of the home, remote from the indoor coil. The
outdoor
unit
has
been
components of the system are ready for easy, immediate
installation.
WARNING: These instructions are intended as an
aid to licensed service personnel. Improper installation may
damage equipment, void the warranty, and can create a
hazard, resulting in injury or death.
A thorough inspection of the shipping container should be
made immediately upon receiving your unit. Look for any
punctures or openings, and if it appears that damage has
occurred, it should be noted on the freight bill before
signing.
The delivering carrier should be contacted
immediately to inspect damage, and no installation work
should begin until this inspection is completed.
manufacturer assumes no responsibility for installation of
incorrectly shipped units.
To alert you to potential hazards, we use the signal words
"WARNING" and "CAUTION" throughout this manual.
"WARNING" alerts you to situations that could cause or
result in serious injury or death. "CAUTION" alerts you to
situations that could cause or result in minor or moderate
injury or property damage.
installation be sure to read and follow all warnings and
cautions.
We also use the words "must" and "should" in this manual.
"Must" is mandatory. "Should" is advisory.
Page 2
The dimensions are
factory
run-tested
and
For a safe and reliable
CAUTION: The manufacturer is not responsible
for the performance of a mismatched system. The outdoor
unit must be installed with a compatible indoor unit as
designated in the specification data or in the Directory of
Certified Unitary Air Conditioners published by the Air
Conditioning and Refrigeration Institute. Using unmatched
components may not only affect the performance of the
system but may also void the warranty of the equipment
SERIES NOMENCLATURE
REFRIGERANT
all
2 = R22
4 = R410a
UNIT TYPE
AC = Air Conditioner
HP = Heat Pump
SERIES
13 = 13 SEER Condensing Unit
14 = 14 SEER Condensing Unit
16 = 16 SEER Condensing Unit
5# = 50 Hz Condensing Unit
NOMINAL COOLING CAPACITY
018 = 18,000 BTUH
024 = 24,000 BTUH
030 = 30,000 BTUH
036 = 36,000 BTUH
The
VOLTAGE
A = 208/230-1-60
B = 208/230-3-60
C = 460-3-60
COMPRESSOR
R = Reciprocating Compressor
S = Scroll Compressor
CONDENSER COIL
C = Cu/Al Coil
M = Aluminum Microchannel Coil
PRODUCT GENERATION
# = Revision Number
2 AC 13 042 A S M 1
042 = 42,000 BTUH
048 = 48,000 BTUH
060 = 60,000 BTUH
D = 575-3-60
E = 230-1-50
F = 380/415-3-50
Installer's Information Manual
Advertisement
Table of Contents
