AEG LAVATHERM 59870 User Manual page 100

100 What to do if ...
Err
( Error )
5)
on the LCD.
No drum light
Abnormally
elapsing time
5)
on the LCD
Programme
inactive
Drying cycle
to short
Drying cycle
6)
to long
1) In case of error message on the LCD (e.g.
programme. Press the START PAUSE button. Does not work? - inform local service and quote the error code.
2) follow program recommendation - see Programme overview chapter
3) see Care and cleaning chapter
4) see Machine settings chapter
5) only dryers with the LCD
6) Note: After around 5 hours the drying cycle ends automatically (see Drying cycle complete section).
Changing the bulb for interior lighting
Only use a special bulb which is designed specially for dryers. The special bulb can be
obtained from your local service centre.
When the appliance is switched on, the interior lighting switches itself off after 4 mi-
nutes when the door is open.
WARNING!
Do not use standard bulbs! These develop too much heat and may damage the appliance!
Before replacing the bulb, disconnect the mains plug; with a permanent connection:
fully unscrew or deactivate the fuse.
1. Unscrew cover above the bulb (this can be found directly behind the loading aper-
ture, at the top; refer to "Description of machine" section.)
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gasket before screwing back the door light cover.
Do not operate the dryer when missing o-ring gasket on door light cover.
WARNING!
For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer
must not be operated.
Attempt to change parameters after
start of the programme.
Programme selector in OFF position.
Defective light bulb.
Time to end is calculated on the basis
of: type, volume and dampness of laun-
dry.
Full water reservoir.
Small laundry volume./Too dry laundry
for selected programme.
Fluff filters clogged.
To high loading volume.
Laundry insufficiently spun.
Particularly high room temperature -
no machine fault.
E51
Turn the dryer off and on. Set reques-
ted parameters.
Turn it to DRUM LIGHT (if available) or
to any programme.
Replace light bulb (see next section).
Automatic process; this is not a ma-
chine fault.
Empty water reservoir
PAUSE button.
Select time programme or higher dry-
ing level (e.g. EXTRA DRY ).
Clean fluff filters.
Respect max. loading volume.
Spun adequately the laundry.
Lower the room temperature if possible.
- only dryers with the LCD): Switch the dryer off and on. Set
3)
, press START