Installing Or Removing Saw Chain - Dolmar AS-1212 Instruction Manual

CAUTION:
- The battery charger is for charging Dolmar battery cartridge.
Never use it for other purposes or for other manufacturer's
batteries.
- When you charge a new battery cartridge or a battery
cartridge which has not been used for a long period of time,
it may not accept a full charge. This is a normal condition
and does not indicate a problem. You can recharge the
battery cartridge fully after discharging it completely and
recharging a couple of times.

Installing or removing saw chain

CAUTION:
- Always be sure that the tool is switched off and the battery
cartridge is removed before installing or removing the saw
chain.
- Always wear gloves when installing or removing the saw
chain.
- Loosen the screws with a screwdriver.
- Remove the sprocket guard (Fig. 3)
- Loosen the bolt with the hex wrench provided.
- Remove the guide bar (Fig. 4)
- Fit the saw chain over the guide bar. Notice that the cutters
must be facing the revolving (arrow) direction (Fig. 5)
- If you charge a battery cartridge from a just-operated tool
or battery cartridge which has been left in a location
exposed to direct sunlight or heat for a long time, the
charging light may flash in red color. If this occurs, wait for
a while. Charging will begin after the battery cartridge
cools. The battery cartridge will cool faster if you remove
the battery cartridge from the battery charger.
- If the charging light flashes alternately in green and red
color, a problem exists and charging is not possible. The
terminals on the charger or battery cartridge are clogged
with dust or the battery cartridge is worn out or damaged.
3
4
5
13