Troubleshooting; Technical Specifications - azur 540R User Manual

TROUBLESHOOTING

When l l istening t t o m m usic i i n s s tereo, L L eft/Right s s peakers a a re
reversed.
Speakers are wrongly connected.
A l l ow h h um o o r b b uzz s s ound c c an b b e h h eard.
Power cords or lighting placed near this product.
Sound i i s o o nly a a udible f f rom o o ne c c hannel
One of the input cords is disconnected.
The balance control is set to one side.
Sound c c uts o o ff w w hen l l istening t t o m m usic o o r t t here i i s n n o s s ound
even t t hough p p ower i i s O O N.
Speaker impedance is less than prescribed for the 540R.
Low b b ass r r esponse.
Speaker polarity (+/-) is reversed.
An u u nusual h h issing n n oise i i s h h eard w w hen l l istening t t o t t he
broadcast i i n s s tereo, b b ut n n ot h h eard w w hen l l istening i i n m m ono.
A slight noise may be heard because the method used for modulation of
FM stereo broadcasts is different than that used for mono broadcasts.
Noise i i s e e xcessive i i n b b oth s s tereo a a nd m m onaural b b roadcasts.
Poor location and/or direction of the antenna.
Transmitting station is too far away.
Sound i i s d d istorted a a nd/or t t he v v olume l l evel b b ecomes l l ow
Broadcast signals are poor or poor antenna placement.
Excessive d d istortion i i n s s peaker o o utput
Poor reception area.
No s s ound f f rom t t he r r ear s s peakers
Surround On/Off button is set to Off.
Source being played is not recorded or broadcast in surround sound or
stereo.
Cable not connected securely.
No s s ound f f rom t t he c c entre s s peaker
Surround mode button is not set to Dolby Digital, DTS or Dolby Pro Logic
II.
Remote h h andset i i s n n ot w w orking
The batteries are flat.
The remote handset is too far from the receiver or out of the effective
range.
12 azur 540R AV receiver

TECHNICAL SPECIFICATIONS

Power O O utput
THD
Crosstalk
Frequency r r esponse
Stby p p ower c c onsumption
Max p p ower c c onsumption
DAC
Connections
Audio I I nputs
Audio O O utputs
Video I I nputs
Video O O uputs
Digital I I nputs
Digital O O utputs
Dimensions ( ( mm)
Weight
100 watts rms per channel,
8 ohms, two channels driven
80 watts rms per channel,
8 ohms all 6 channels driven
<0.006% @1kHz
<-60dB
20Hz – 20kHz +/- 1dB
<2w
850w
CS42518 Multi-DAC
CS493263 DSP
6 Line Level + Tuner
6.1 Direct Input
6 Amplified Speaker Outputs
6.1 Preamp output
1 Tape record output
4 Composite, 3 S-Video,
2 Component Video
1 Composite, 1 S-Video,
1 Component Video
2 Co-Axial, 3 Optical
1 Co-Axial, 1 Optical
430 x 100 x 310
9.5kg/20.9lbs