GamerModz JUGGERNAUT Instruction Manual page 14

QUICK SCOPE MOD – PROGRAMMING A MODE
The Quick Scope Mod has 5 Programmable Modes.
Once you are in the Mode you wish to Program, Hold Down the Left Trigger and Hold Down Left on D-Pad
until the LED Begins Flashing, then Release the Left Trigger . The PS4 Controller LED will flash 5
times letting you know that you are now in Programming Mode.
Until LED
1 , then
, then
Begins to Flash X
Once in Programming Mode you can adjust the timing of the Quick Scope Mod. Please follow the steps below
to optimize the timing for quick scope.
Step 1: Go into a game; choose a load out with the sniper rifle you want to configure and locate a wall in the
game that you can fire at. Be aware that perks that change the weapon ready speed, different scopes, etc. -
will affect optimal timing of the Quick Scope Mod.
Step 2: Enable the Quick Scope Mode you would like to Program (Refer to Page 10 "Quick Scope Mod – Choosing
a Mode")
Step 3: Enter Programming Mode (See Above)
Step 4: Tap Up on the D-Pad to Increase or Down on the D-Pad to Decrease the time between how
long the scope takes to come up and when the firing happens. After every adjustment you can test the setting
by Tapping the Left Trigger .
What you are looking for when testing is finding the setting where every time you tap the Left Trigger, the scope
comes up, the gun fires and all the rounds hit the same spot on the wall. By default, all 5 Modes are configured
for the L115 in Call of Duty Ghosts with no perks on that affect the timing.
Step 5: Once you have found the ideal setting, Tap Left on the D-Pad and the LED will flash the
corresponding amount of times for that setting. For example, a Setting of 50, will flash the LED 50 times.
Note: To setup a different Quick Scope Mode, simply enter the mode and repeat the programming process
above.
–