General Safety Instructions - GMC TP2000 Instruction M

General safety instructions

To use this tool properly, you must observe the safety
regulations, the assembly instructions and the operating
instructions to be found in this Manual. All persons who
use and service the machine have to be acquainted
with this Manual and must be informed about its
potential hazards.
Children and infirm people must not use this tool.
Children should be supervised at all times if they are in
the area in which the tool is being used. It is also
imperative that you observe the accident prevention
regulations in force in your area. The same applies for
general rules of occupational health and safety.
Warning. When using power tools, basic safety
precautions should always be taken to reduce the risk of
fire, electric shock and personal injury. Also, please read
and heed the advice given in the additional important
safety instructions.
1. Keep the work area clean and tidy.
areas and benches invite accidents and injury.
2. Consider the environment in which you are working.
Do not use power tools in damp or wet locations. Keep
the work area well lit. Do not expose power tools to
rain and high humidity. Do not use power tools in the
presence of inflammable liquids or gases.
3. Keep visitors away from the work area.
and onlookers, especially children and infirm persons,
should be kept well away from where you are working.
Do not let others in the vicinity make contact with the
tool or extension cord.
4. Store tools safely. When not in use, tools should be
stored in a dry, high place or locked up out of reach.
5. Do not force the tool.
and safer working at the rate for which it was
designed.
6. Use the correct tool for the job.
tools or attachments to do the job best handled by a
Cluttered work
All visitors
The tool will do the job better
Do not force small
heavier duty tool. Never use a tool for a purpose for
which it was not intended.
7. Dress correctly. Do not wear loose clothing or
jewellery. They can be caught in moving parts. Rubber
gloves and non-slip footwear are recommended when
working outdoors. If you have long hair, wear a
protective hair covering.
8. Use safety accessories.
should always be worn. A face or dust mask is
also required.
9. Connect dust extraction equipment.
provided for the connection of dust extraction and
collection facilities, ensure that these are connected
and properly used.
10. Do not abuse the power cord.
disconnect the tool from the power point. Keep the
cord away from heat, oil and sharp edges.
11. Do not overreach.
balanced at all times.
12. Look after your tools.
better and safer performance. Follow the instructions
regarding lubrication and accessory changes. Inspect
tool cords periodically and, if damaged, have them
repaired by an authorised service facility. Inspect
extension cords periodically and replace them if
damaged. Keep tool handles dry, clean and free from
oil and grease.
13. Disconnect idle tools.
disconnect the plug from the power point before
servicing, when changing accessories and when the
tool is not in use.
14. Remove adjusting keys and wrenches.
that keys and adjusting wrenches are removed from
the tool before switching on.
15. Avoid unintentional starting.
switch is in the OFF position before plugging in the
tool to the power supply. Do not carry a plugged in
tool with your finger on the switch.
4
Safety glasses and earmuffs
If devices are
Never pull the cord to
Keep your footing secure and
Keep tools sharp and clean for
Switch off the power and
Check to see
Always check that the