Tranquil PC SQA-5H Installation Manual page 15

Home Server Console – Backup button
You can either run a server backup to your nominated backup hard disk by using the console,
or you can use the Backup button on the front panel of the Home Server
Using the Backup button
To initiate a previously 'remembered' backup, simple
insert / add your nominated backup HDD to the Server
and press the blue Backup button.
As the backup progresses, the LED will flash yellow once the
backup is completed the LED will be green for a few
moments, then go off.
If there is a fault with the backup, for any reason, you will see
a red LED. If the Backup button operation fails, open the
console for information why the backup failed.
Back to Index page
D03_ WHS_PP1_UK
Adding a new Hard Disk - Hardware
The adding of extra Hard Disk Drives (HDDs) to you server is easy.
To eject the empty HDD carrier, just push the coloured tab to the left, and the alloy lever is released, push the
lever down, then pull the carrier out.
Lay you new HDD on a desk, with the data connectors away from you, and then carefully open the alloy
carrier side bars, so that you can position them over the edges of the HDD. There are 4x steel pins which then
should engage into the holes in the side of the HDD. Press the sides together, so that the HDD is firmly held in
place.
Then re-insert the HDD and carrier back into the Server.
Please note adding HDD2 requires a power down of the Server, before it can be added.
Adding HDD3, HDD3 and HDD5 does not require a power down.
RED Tabs – indicate 'non Hot Swap' – GREEN -
TIP : You may want to make a note of the date the HDD is added to your server, on the labels
provided. This can be useful for tracking how long the HDDs have been in service
Back to Index page
D03_ WHS_PP1_UK
BLUE Tabs indicate 'Hot Swap'
11/29/2009
15