Important Information; For Your Safety - Panasonic DP-MC210 Operating Instructions Manual

1 I mportant Information

Important Information

For your safety

Laser radiation
The printer of this unit utilizes a laser. Use of
controls or adjustments or performance of
procedures other than those specified
herein may result in hazardous radiation
exposure.
Fuser unit
During or immediately after printing, the
fuser unit (1) gets hot. This is normal. Do
not touch the fuser unit.
Note:
L The left side of the unit (2) and the area near the
recording paper exit (3) also get warm. This is
normal.
1
For best performance
Toner cartridge and drum cartridge
L When replacing the toner cartridge or drum
cartridge, do not allow dust, water, or liquids to come
in contact with the drum. This may affect print quality.
L For optimal performance, genuine Panasonic toner
cartridges and drum cartridges are recommended.
We cannot be responsible for problems that may be
caused by a non-Panasonic toner cartridge or drum
cartridge:
– Damage to the unit
– Poor print quality
– Improper operation
Toner cartridge
L Do not leave the toner cartridge out of the protection
bag for a long time. It will decrease the toner life.
Drum cartridge
L Read the instructions on page 11 before you begin
installation of the drum cartridge. After you have read
L To extend the life of the drum cartridge, the power
Location
L To avoid malfunction, do not position the unit near
Static electricity
L To prevent static electricity damage to the interface
Environment
L Keep the unit away from electrical noise generating
3
L The unit should be kept free from dust, high
L The unit should not be exposed to direct sunlight.
L Do not place heavy objects on top of the unit. When
2
L The unit should be kept away from heat sources such
L In the printing process, heat is used to fuse toner
L Do not place any objects within 10 cm (4 inches) of
them, open the drum cartridge protection bag. The
drum cartridge contains a photosensitive drum.
Exposing it to light may damage the drum. Once you
have opened the protection bag:
– Do not expose the drum cartridge to light for
more than 45 seconds.
– Do not touch or scratch the green drum surface.
– Do not place the drum cartridge near dust or dirt,
or in a high humidity area.
– Do not expose the drum cartridge to direct
sunlight.
switch should never be turned OFF immediately after
printing. Leave the power turned ON for a minimum
of 30 minutes after printing.
appliances such as TVs or speakers which generate
an intense magnetic field.
connectors or other electrical components inside the
unit, touch a grounded metal surface before touching
the components.
devices, such as fluorescent lamps and motors.
temperature and vibration.
you leave the unit unused for a long period of time,
unplug this unit from the power outlet.
as heaters, kitchen stoves, etc. Damp basements
should also be avoided.
onto the page. As a result, it is normal for the
machine to produce an odour during and shortly after
printing. Be sure to use this unit in an area with
proper ventilation.
the right, left and back sides of the unit.
Important Information
3