Summary of Contents for Helipal Lumenier QAV 210 Storm Edition
Page 1
Lumenier QAV 210 Storm Edition QUICK START GUIDE Copyright@2015 HeliPal.com. All Rights Reserved...
Page 2
6) Never overcharge LiPo batteries. Do not charge above 4.2V per cell. When the battery is fully charged, disconnect it from the charger. Never leave the battery charger unattended during charging. 7) Never discharge batteries to below 3.3V per cell 8) Remove batteries when not using the drone. Copyright@2015 HeliPal.com. All Rights Reserved...
Page 3
3. 6pcs Clockwise HQ 5 x 4 x 3 Tri-Blade Propeller 4. 6pcs Counter-Clockwise 5 x 4 x 3 Tri-Blade Propeller 5. 2.0 mm Hex Wrench (for motor screws) 6. 10mm Hex Nut Driver Driver (for motor cap) Copyright@2015 HeliPal.com. All Rights Reserved...
Page 4
Quick Start Copyright@2015 HeliPal.com. All Rights Reserved...
Page 5
Copyright@2015 HeliPal.com. All Rights Reserved...
Page 10
= 8, our suggested value is 8 and you may increase the value till 20 but the best solution is fly your drone under manual mode as it is your final goal for flying racing drone. Copyright@2015 HeliPal.com. All Rights Reserved...
Page 11
What is the difference between different LED status? Copyright@2015 HeliPal.com. All Rights Reserved...
Page 12
1) Press and Hold the controller wheel (With wordings 2) [STK-MODE] = 2 (Stick Mode) “PUSH”) to unlock the manual. Press and Hold Mode [LockScreen] = 30s (Time to lock screen) Button to go into basic menu page Copyright@2015 HeliPal.com. All Rights Reserved...
Page 13
[1] [AILE] = NOR [2] [ELEV] = REV [3] [THRO] = REV [4] [RUDD] = NOR [5] [ATTI] = NOR [6] [AUX1] = NOR [7] [AUX2] = NOR [8] [AUX3] = REV Copyright@2015 HeliPal.com. All Rights Reserved...
Page 14
10) Go to [F/S], apply the setting below: [1] [AILE] = NOR [2] [ELEV] = NOR [3] [THRO] = 15% [4] [RUDD] = -70% [5] [ATTI] = NOR [6] [AUX1] = NOR [7] [AUX2] = NOR [8] [AUX3] = NOR Copyright@2015 HeliPal.com. All Rights Reserved...
Page 15
Download OPENTX program by isiting http://www.open-tx.org/downloads.html. Always use the latest version Use the latest OPENTX 2.1 branch. Download the latest helipal profile for our drone here (Please unzip before use): www.helipal.com/download/uav/srd-taranis-x9d-plus.zip OR http://goo.gl/PZQeWO Turn on your radio by holding both lower trim buttons towards the center while you turn it on, you should be entering BootLoader Page Connect your TARANIS profile to your PC/Mac via USB Cable and wordings “USB...
Page 16
Click to open our profile, drag and drop to copy the profile to your own one. Click to write to write the settings to your radio otherwise no changes will be applied. Copyright@2015 HeliPal.com. All Rights Reserved...