Assembly - NordicTrack 831.298810 User Manual

Assembly

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Assembly
requires a phillips screwdriver
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. With the help of a second person, carefully raise the
Uprights (70) until the Wheels (30) are resting flat on the
floor.
2. Remove the four Handrail Screws (103) from the posts on
the left and right Uprights (70). Slide the upper end of a
Handrail (101) onto the post on the left Upright. Note: It
will be necessary to pivot the Handrail to the side and
back repeatedly (see arrow A) while pushing on the
Handrail to slide it fully onto the post. Next, pivot the
lower end of the Handrail down and pull back on it (see
arrow B) to align it with the hole in the left Upright.
Loosely thread a Handrail Bolt (95) with a Handrail Washer
(102) into the left Upright (70) and the lower end of the
Handrail (101). Tighten two Handrail Screws (103) into the
upper end of the Handrail and the left Upright. Tighten the
Handrail Bolt.
Attach the other Handrail (101) to the right Upright (70) as
described above.
and an adjustable wrench
1
2
101
B
6
(not included).
Post
103
70
95
A
102
101
Hole
70
30
70
103
95
102