O.seat Sling Adjustment; Ultra Light Seat Sling; Q.cushion Installation; Storage Tips - Quickie 7R Owner's Manual

Q UI C KIE 7R
O. SEAT SLING ADJUSTMENT
Remove the screws (A) retaining the left side seat sling. Readjust VELCRO®-style material to
increase the tension in the seat sling. Replace screws. If there is any difficulty in reattaching the
screws, try using a probe to help align the holes. Ensure that the plastic saddles (B) are under the
seat rail in all fastener positions.
P. ULTRA LIGHT SEAT SLING
The Ultra Light Seat Sling may be removed by first loosening the Velcro strap (C) on both the front
and rear of the seat upholstery cover ( E). Then proceed by loosening all Velcro straps (D) that
encircle the chair frame. All straps must be reinstalled in the same position and quantity as the orig-
inal set-up.
Q. CUSHION INSTALLATION
Place cushion on seat sling with VELCRO® side down. The beveled edge of the cushion should be
in front. Press firmly into place.
R. STORAGE TIPS
1. Store your chair in a clean, dry area. If you fail to do so, parts may rust or corrode.
2. Before using your chair, make sure it is in proper working order.
3. Inspect and service all items on the "Maintenance Chart".
4. If stored for more than three months, have your chair inspected by an authorized dealer
before use.
S. CHECK-OUT
After the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should also
perform smoothly. If you have any problems, follow these procedures:
1. Review the set-up and check-out sections and operating guide to make sure chair was properly
prepared.
2. Review the troubleshooting chart at the beginning of this section.
3. If your problem persists, contact your authorized dealer. If you still have a problem after contacting your
authorized dealer, contact Sunrise customer service. See the Introduction Page for details on how to con-
tact your authorized dealer or Sunrise customer service.
25
26
VIII. USE AND MAINTENANCE
19
25
B
26
E
MK-100084 Rev. A