Hospital Mode - Panasonic TH-32LRH30U Service Manual

TH-32LRH30U
5.3.

Hospital mode

1. Purpose
Restrict a function for hospitals.
2. To display Hospital mode setup menu
Press [MENU], [G], [Y] and [0] buttons on the remote con-
trol by turns.
Then, the Hospital mode setup menu is displayed.
3. Setting for each items
Select item by [UP]/[DOWN] button on the remote control
and change the setting by [LEFT]/[RIGHT] button on the
remote control. After the setting, select [Save] and press
[OK] button on the remote control to store.
4. To exit the Hospital mode setup menu
Disconnect the AC cord from wall outlet, or press and
hold the [POWER] button at right side on the main unit for
10 seconds or more.
5. Explain the Hospital mode setup menu
item
Mode Select hospital mode off/on
TA Ctrl Sets TA (Terminal Adapter) status. (Internal/
External/Local Auth/Off)
Internal: Use Internal TA
External: Use External TA
Local Auth: Local Authentication mode
Initial input Selects Input when the TV is turned on.
Does not operate when input from TA to the
TV is prohibited.
(-/RF/HDMI 1-2/Component/Video1-2/PC)
Initial channel Sets the channel at power-on.
Initial volume Sets the volume level at power-on. (0-100)
Does not operate when control from TA to
the TV is prohibited.
Max.volume Sets the maximum volume level. (0-100)
OSD Ctrl Limits the OSD display. (Off/Pattern1)
Pattern 1: [Recall] and [Shut-off notification]
messages are not displayed at power-on.
Also displayed when [Pattern 1] is specified
as the display command from TA.
Button lock Limits the TV panel button operation. (Off/All/
Pattern1)
Pattern 1: Only INPUT and POWER buttons
are available.
All: All buttons are not available.
Power ctrl Sets the screen condition when the AC
power is switched on. (Off/On)
Off: Starts up in last screen.
On: Starts up in screen On.
Remote Switches Operation guide according to
remote control. (Panasonic/Others)
CC reset Sets CC setting status. (On/Off)
On: Resets all CC settings to defaults.
Off: Saves the last settings.
Lock reset Sets Lock setting status. (Off/On)
Off: Saves the last settings.
On: Resets all Lock settings to defaults.
CC Priority Select CC standard to be prioritized (EIA-708
or EIA-608). (708/608)
Com warning Off: Hides warning panel of communication
error when connecting with STB etc. (Off/On)
(Especially when connecting with GuestTek/
nSTREAM Analog VOD system, switches
this menu to [Off] .)
Welcome Image Sets Welcome Image status. (3sec/5sec/
7sec/Off/Load Image)
CP Mode On: When using input switching commands
with RS232 connection while connected to
STB, switch Menu to [On] . (Off/On)
HDMI Audio Sync Switch to Mode 2 if experiencing problem
with HDMI audio. (Mode1/Mode2)
Pillow speaker Sets the Pillow speaker status. (On/Off)
IR code Sets the IR code status. (Panasonic/VOD/LG
(Zenith)/RCA/Philips/Analog)
Voltage supply Sets the Voltage supply of Pillow speaker.
(12V/5V/-5V)
Speaker Sets the speaker output. (Internal/Pillow)
10
Function