Table of Contents
Advertisement
Satellite Setting
Once you have completed setting the digital
receiver to your individual preferences, you can
proceed, if necessary, to adjust the unit settings
to your antenna. The menu [Satellite Setting]
contains the satellites that have been selected
in the installation assistant. If the installation
assistant was interrupted, the satellite position
[Astra19.2E] is pre-programmed. Should you
wish to receive other satellites, or if you are
using a different type of LNB, you can adjust
your digital receiver to the appropriate data as
follows:.
Antenna Setting
1. Select [Satellite Setting] option in the [DTV]
menu, then press ENTER ( ).
NOTE
If the [DTV Lock] option is set to [Lock], this
function is available when you enter the password
correctly. (page 34).
2. The [Satellite Setting] menu appear on the
screen. Use U / u to select the [Antenna
Setting] and then press ENTER ( ).
3. Use I / i to select a desired particular
satellite.
BD582SC-P.BDEULLK_MFL65225402_ENG.indd 15
4. Select an item using U / u . If you know the
programmed [LNB Frequency], [22kHz
Tone], [DiSEqC], [LNB Power], [Transponder]
and [Motor], use I / i to select the desired.
If you select [DiSEqC 1.2], you can set Motor
Driving Mode, Motor Move and Set Limit,
and if you select [USALS], you can set the
longitude and latitude and use u to select
[Go to position]; then motor will move to
your selelected satellite as calculating its
position.
NOTE
If you use USALS, you should know lines of
longitude and latitude at your location.
5. Use U / u to select the [Save] and press
ENTER ( ) to display the [Saved List] menu.
NOTE
If there isn't LNB Frequency what you want in [LNB
Frequency], input LNB Frequency with numerical
buttons.
6. Use U / u / I / i to select the [Go To Tuning]
and press ENTER ( ).
Installation
15
3
10. 9. 17.
7:38
Advertisement
Table of Contents
