Table of Contents
Advertisement
Connections
¥ The power cord must be connected only after all other
cable connections are completed.
Connecting speakers
Right speaker
When connecting only one set of speakers, connect to
the SPEAKERS A terminals as shown in the illustration.
Make correct connection between the unit's jacks and
speaker's jacks (i to i and j to j) for each channel. If
connection is wrong, a bass sound may become poor due
to reverse phase.
0 Connect speakers with 4 h to 16 h impedance. You
have to change the impedance setting if any of the
speakers have 4 h or more to less than 6 h
impedance. See setup menu "3. Hardware" - "Speaker
Impedance" (
36).
12 - 15 mm (1/2" - 5/8")
Twist the wires of the speaker cable tightly before
inserting into the terminals. After inserting the cables,
tighten the terminals firmly by turning to the right. Note
that when using commercially available banana plugs,
first tighten the speaker terminals and then insert the
banana plugs. It is not possible to connect by inserting
the core of the speaker cable directly into the hole for a
banana plug.
Left speaker
When also connecting to the SPEAKERS B terminals:
Connect using the same method described for
SPEAKERS A. Connect speakers with 8 h to 16 h
impedance to the both A/B terminals. In this case, change
the impedance setting on this unit. See setup menu "3.
Hardware"-"Speaker Impedance" (
0 Press the SPEAKERS A/B button on the unit or the
remote control to switch the speakers. (The selection
changes in the order SPEAKER A#SPEAKER
B#SPEAKER AiB.)
Banana plug
36).
11
It
De
Hide quick links:
Advertisement
Table of Contents
