Assembly And Installation - Danby DAC060EUB7GDB Owner's Use And Care Manual

INSTALLATION INSTRUCTIONS

ASSEMBLY AND INSTALLATION

1. Assembly of the upper channel to the cabinet (factory installed on some units).
• "L" Shaped Top Channel: install the "L" shaped channel to the top of the cabinet as shown in Fig. 3, using four (4)
3/8 in. (9.5 mm) screws.
2. Assembly of the side curtains to the cabinet.
• Extend the shutter from the shutter frame and slide it into the shutter tabs on the side channel of the air conditioner,
as shown in Fig. 4.
• Slide the shutters into the top ("L" shaped) and bottom ("U" shaped) channels. The shutters are identifi ed (on frame)
as left and right.
Fig. 3
3. Completing the installation.
• Cut the foam (non adhesive) sealing strip to fi t the area of the window sill that the air conditioner will rest on.
• Carefully place the air conditioner into the window with the "L" shaped mounting bracket (on top) positioned in front
of the upper window sash. The bottom of the cabinet should be positioned on the "recessed" portion of the window
frame. Pull the window down until it rests just behind the front fl ange of the (top) "L" shaped mounting bracket (See
Fig. 5).
• Expand the shutter frames (fully) on each side and secure the top of the frames to the window sash using one 1/2 in.
(13 mm) screw on each side and one in the "L" shaped mounting bracket (Fig. 5).
• Secure the shutter clamp on each side of the lower part of the shutter, and secure to window sill using one 1/2 in.
(13 mm) screw on each side (Fig. 5).
• Place the second foam sealing strip to fi t the opening between the inside and outside windows, then attach the safety
lock to the outside window frame using one 1/2 in. (13 mm) screw (See Fig. 6).
PLEASE NOTE: Window applications come in a variety of different styles. Therefore, it may be necessary to modify your
particular installation.
Fig. 5
1/2 in. (13mm) screws
Shutter clamps
3/8 in. (9.5 mm)
"L" shaped mounting
bracket
"U" shaped Channel
(Factory Installed)
Window sash
Fig. 6
"L" Shaped
Mounting
Bracket
6
Fig. 4
Shutter tabs
Shutter
Shutter frame
Safety Lock
1/2 in. (13 mm) screw
Foam Seal
(adhesive)