1 Fastening screws of the casing top
2 Housing top
3 Bearing bowl incl. spring clamp and switch cams
4 Bearing bowl incl. spring clamp
Pull the bearing bowls off to the side.
Unscrew locking screws.
Remove the top part of the casing.
1 Suction turbine
2 Power cord
3 Terminal strip of the suction turbine
4 Connection cable to the brush head
5 Connection cable of the suction turbine
Remove the suction turbine.
Pull the connecting cable of the suction turbine out of the termi-
nal strip.
Install the new suction turbine in reverse sequence.
Note: The mains cable must be routed as shown in the illustration
within the respective pins (see arrows).
5.10 Replace seal
3
1 Casing bottom
2 Power cord
3 Seal
Remove the seal.
Insert new seal.
Note: The seal must be placed precisely into the guide groove of
the casing bottom to protect the suction turbine from contamina-
tion.
8
English 5.906-485.0 Rev. 00 (05/09)
6
1
2
3
4
5
1
2
Maintenance and care