Routing - D-Link DWR-921 User Manual

Section 4 - Configuration
The Routing page allows you to specify custom routes that determine how data is moved around your network.
RIP: Check the box to enable routing, then select which routing
protocol to use:
• RIPv1: Protocol in which the IP address is routed
through the Internet.
• RIPv2: Enhanced version of RIPv1 with added
features such as authentication, routing domain, next
hop forwarding, and subnet-mask exchange.
ROUTING RULES
ID: This identifies the rule.
Destination: Enter in the IP of the specified network that you want to access
using the static route.
Subnet Mask: Enter in the subnet mask to be used for the specified network.
Gateway: Enter in the gateway IP address for the specified network.
Hop: Enter in the amount of hops it will take to reach the specified
network.
Note: In a transmission path, each link is terminated at a network
device such as a router or gateway. The number of hops equals
the number of routers or gateways that data must pass through
before reaching the destination.
Enable: Select this box to enable the rule.
Click Apply to save your settings, or Refresh to revert to your
previous settings.
D-Link DWR-921 User Manual

Routing

41