Advertisement
Installation
Shelving
The glass shelves and wire rack are removable for you to create a configuration
that best suits your beverage needs.
To remove a shelf, gently tip the shelf up and pull out of the unit. Slide back in the
desired position.
Cleaning and Maintenance
WARNING: To avoid electrical shock, always unplug unit before cleaning. Failure
to follow this instruction can result in death or injury.
NOTE: Any time the unit is unplugged, the temperature will default to the factory
setting. Reset your desired temperature setting.
Cleaning
General:
•
Prepare a cleaning solution of 3-4 tablespoons of baking soda mixed with warm
water.
•
Using a soft cloth or sponge, dampened with the cleaning solution, wipe down
interior and exterior of unit.
•
Rinse with clean, warm water and dry with a soft cloth.
•
Never use an abrasive cleanser or pad as this could damage the finish.
NOTE: Removable racks and shelves should only be handwashed.
Gaskets:
•
Clean door gaskets every three months according to the general instructions
shown above.
•
Apply a thin layer of petroleum jelly to the hinge side of the gasket to keep the
gasket pliable and to ensure a good seal.
Defrosting:
The Beverage and Wine Center is designed with a manual defrost system. The unit
will defrost when it is unplugged. Water is automatically channeled to the drip tray
on the back of the unit. Heat transfer from the compressor will evaporate the water
when the unit is running.
6
(cont'd)
Wards.com
Cleaning and Maintenance
Power Interruption
Remove the power cord from the electrical outlet when a power outage occurs.
Replace the plug to the AC outlet when power is restored. The temperature will
default to the factory setting. Reset your desired temperature setting.
Long Term Care and Moving
When the Beverage and Wine Center will not be used for an extended period of
time, remove contents, unplug unit and clean according to general cleaning instruc-
tions. Prop the door open to allow air circulation.
Only move the unit when it is vertical. Moving the unit in a horizontal position can
cause damage to the refrigerant and compressor.
Troubleshooting
Problem
Possible Cause
Unit makes a bubbling
Refrigerant is passing
sound.
through the cooling coils.
Unit makes a clunking
The unit is not level.
sound.
Beverages are not
Thermostat is set at too
cold.
high of a temperature.
Proper amount of airflow
is not maintained.
Door is not fully sealed.
Beverages are frozen.
Thermostat is set at too
cold of a temperature.
Ice buildup on interior
Thermostat may be
walls.
faulty.
1
(cont'd)
Remedy
This is normal operation.
Adjust the leveling legs.
Adjust the temperature to
a colder setting.
Allow 1/2 inch of space
between items and inside
walls.
Make sure door is shut
properly and that gaskets
are tight and clean.
Adjust the temperature to
a warmer setting.
If lowering the temperature
does not fix the problem,
call for customer service.
888
557
3848
•
•
•
7
Advertisement
