System Setup Guides; Samsung Srp-500/Samsung Sps 1000 Logo Setup Guide - Samsung SRP-500 Integrator's Manual

System Setup Guides

Samsung SRP-500/Samsung SPS 1000 Logo Setup
Guide
The Samsung SPS-1000 can take advantage of the two-color graphic logo printing capabilities
of the Sansung SRP-500. This document provides the SPS-1000 settings required to print the
SPS-500 graphic logo.
Printer Driver Selections
1. Select PRINTER
DRIVER
SELECTIONS from
the S-MODE
PROGRAMMING
MENU to display the
PRINTER DRIVER
SELECTIONS
screen.
2. Select SAM SRP-
270.
3. Set the START and
CANCEL commands
as shown on the
screen at the right.
Note that the LOGO
start command is
1B6701 and the
Initialize command
should be deleted.
NOTE: Use the start command 1B6701 to print the first image loaded into the SRP-500.
Use the sequential commands, 1B6702 to 1B6710 to print the remaining 9 images that
may be stored in the SRP-500.
Samsung SRP-500 Setup & Service Information
PRINTER DRIVER SELECTIONS
PRINTER TYPE
SAM SRP-100 INITIALIZE
SAM SRP-270 COMPRESSED
SAM SRP-350 RED/REV
CITIZEN 3551 EXPANDED
CITIZEN 810 BOLD
CITIZEN 230 UNDERLINE
EPSON T88-2 LONG FEED
EPSON U200 FULL CUT
EPSON U295 PART. CUT
EPSON U300 STANDARD
EPSON U325 LOGO
u u
START
1B6701 1B7200
1B2121 IB2101
1B4501 1B4500
1B2D01 1B2D00
1B64
IB69
1B69
1B6701
ESC ENTER PAGE UP/DN ↑ ↓
System Setup Guides • 23
CANCEL