LG LRG411 5ST Owner's Manual page 51

Replacing the Door
1 Firmly grasp both sides of the door at the top.
2
With the door at the same angle as the removal
position, seat the indentation of the hinge arms
into the bottom edge of the hinge slots. The
notch in the hinge arms must be fully seated into
the bottom edge of the slots.
,,,'" Bottom
,," edge of slot
indentation
3
Open the door fully. If the door witl not open fully,
the indentation is not seated correctly in the
bottom edge of the slots.
4
Lock the hinge locks, rotating them back toward
the slots in the oven frame until they lock.
Hinge arm
Hinge lock
5 Close the oven door.
MAINTENANCE 51
Removing the Drawer
CAUT,O.
isconnect the electrical power to the range at |
I the main fuse or circuit breaker panel. Failure to |
I do so can result in severe personal injury, death,
or electrical shock {
J
Most cleaning can be done with the drawer in place;
however, the drawer may be removed if further
cleaning is needed. Use warm water to thoroughly
clean.
1 Fully open the drawer.
2
Locate the glide lever on each side of the
drawer. Push down on the left glide lever and
pull up on the right glide lever.
Lever
Push down with finger Pull up with finger
3
Pull the drawer away from the range.
Replacing the Drawer
1
Pult the bearing glides to the front of the chassis
glide.
2 Align the glide on each side of the drawer with
the glide slots on the range.
3 Push the drawer into the range until levers click
(approximately 2 inch).
4 Pull the drawer open again to seat bearing glides
into position.