Zanussi ZBA22422SA User Manual page 20

Problem
The appliance is noisy.
The lamp does not work.
The compressor operates contin-
ually.
There is too much frost and ice.
The compressor does not start
immediately after pressing the , or
after changing the temperature.
Water flows on the rear plate of
the refrigerator.
Water flows into the refrigerator.
Water flows on the floor.
The temperature in the appliance
is too low/too high.
20
Possible cause
There is no voltage in the mains
socket.
The appliance is not supported
properly.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incorrectly.
Many food products to be frozen
were put in at the same time.
The room temperature is too
high.
Food products placed in the ap-
pliance were too warm.
The door is not closed correctly
or the gasket is deformed/dirty.
The water drainage plug is not
correctly positioned.
Food products are not wrapped
properly.
Temperature is set incorrectly.
This is normal, no error has oc-
curred.
During the automatic defrosting
process, frost melts on the rear
plate.
The water outlet is clogged.
Food products prevent that water
flows into the water collector.
The melting water outlet is not
connected to the evaporative tray
above the compressor.
The temperature regulator is not
set correctly.
The door is not closed correctly.
Solution
Connect a different electrical ap-
pliance to the mains socket. Con-
tact a qualified electrician.
Check if the appliance stands
stable.
Close and open the door.
Refer to "Replacing the lamp".
Refer to "Operation" chapter.
Wait some hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before storing.
Refer to "Closing the door".
Position the water drainage plug
in the correct way.
Wrap the food products better.
Refer to "Operation" chapter.
The compressor starts after a pe-
riod of time.
This is correct.
Clean the water outlet.
Make sure that food products do
not touch the rear plate.
Attach the melting water outlet to
the evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door".
www.zanussi.com