Table of Contents
Advertisement
INSTALLATION OF THE MEDIAMASTER
The box for your Mediamaster should contain the
following items:
• the Mediamaster
• a remote control with 2 AAA batteries
• a SCART lead (fully featured 1,0 metre)
• an aerial/RF lead (double screened 1,5 metres)
• an Owner's Manual (this document)
• a Software License agreement
About the SCART sockets
• The rear panel of the Mediamaster is equipped with 2 SCART
sockets (see diagram). When you connect other products
to any of these sockets, always use fully featured SCART
leads (as supplied). There are "less well specified" SCART
leads on the market and picture quality could be reduced if you
use them.
Preparing the Remote Control
• Remove the cover on the battery compartment at the bottom
of the remote control.
• Insert the 2 AAA (1,5 V) batteries, as shown in the diagram,
taking care to observe the + and - markings indicated inside.
• Replace the cover.
Connecting the Mediamaster to the Dish
If you need to fit the F-connectors onto the cable
• Prepare each end of the cable as shown in the diagram. You
will need to fold back the outer braid (as shown).
• Slide the F-connector onto the cable, then turn it clockwise
until it grips the braid.
• Ensure that 3 mm of the core is protruding from the end of the
connector.
Installing the Satellite Dish
• See the "Fitting instructions for satellite dish" on how to in-
stall the dish.
• Connect the coaxial cable, with F-connectors fitted, from the
LNB on the satellite dish to the socket marked "ANTENNA"on
the rear panel of the Mediamaster (or e.g. a DiSEqC switch).
GB 8
SCART lead
RF lead
License
Owner's manual
agrement
SCART socket
15 mm
8 mm
F-connector
3 mm
Advertisement
Table of Contents
