Related Manuals for Nokia MEDIAMASTER 9800 S
Summary of Contents for Nokia MEDIAMASTER 9800 S
- Page 1 Owner’s Manual Mode d’emploi Istruzioni per l’uso Instrucciones de uso MEDIAMASTER 9800 S GB 1...
- Page 2 If in doubt, consult a qualified electrician. Nokia Multimedia Terminals operates a policy of continuous development. Therefore we reserve the right to make changes and improvements to any of the products described in this manual without any prior notice.
-
Page 3: Table Of Contents
MEDIAMASTER 9800 S Contents VIEWING MODE GENERAL OPERATION OF THE MEDIAMASTER General Information Programme Information FOR YOUR SAFETY The “i” (Information) Button REMOTE CONTROL Rear Panel Guide List of TV or Radio Channels Front Panel Options (Green Button) ABOUT THE SMARTCARD AND CA MODULE 7... -
Page 4: General Operation Of The Mediamaster
• Do not cover the Mediamaster or place cold or humid conditions. it on a unit that emits heat. • Service should be carried out only at a Nokia • Use a soft cloth and a mild solution of Authorised Service Centre. -
Page 5: Remote Control
REMOTE CONTROL This section describes how to operate the Mediamaster using the buttons on the remote control. Some of the functions can also be carried out using the buttons on the front panel. To switch the Mediamaster in and out of standby mode. EXIT TV To return to the viewing mode from a menu without s t o r - ing settings (in menu mode). -
Page 6: Rear Panel
Rear Panel Mains lead DIGITAL AUDIO AUX SCART TV/VCR ANTENNA * 95-260 V AC phono connector for the connection to a for an RF- Satellite dish 50-60 Hz S/PDIF output for VCR, or an analogue cable to the input (F- connection to satellite receiver aerial input... -
Page 7: About The Smartcard And Ca Module
ABOUT THE SMARTCARD AND CA MODULE To be able to receive scrambled digital satellite channels you will need a Smartcard and/or a Common Interface CA (Conditional Ac- cess) module from the Service Provider of your choice. The Service Provider is the programme distributor. If you are subscribing to services from more than one Service Provider, you might have to change between different Smart- cards and/or CA modules. -
Page 8: Installation Of The Mediamaster
INSTALLATION OF THE MEDIAMASTER The box for your Mediamaster should contain the MEDIAMASTER 9850 T following items: • the Mediamaster • a remote control with 2 AAA batteries • a SCART lead (fully featured 1,0 metre) • an aerial/RF lead (double screened 1,5 metres) SCART lead RF lead •... -
Page 9: Connecting The Mediamaster To The Tv
Connecting the Mediamaster There are many different types of TV/VCR and other equipment that you can connect to the Mediamaster. In this manual you will see some of the most common ways to connect your equipment. If you use RF leads you will have to tune your TV and VCR to the Mediamaster output channel (see page 11). -
Page 10: Connecting An Analogue Satellite Receiver And Vcr
(at A B in the diagram) or a Universal Twin LNB. Analogue receiver Nokia Smart priority switch • Connect a coaxial cable between output A on the NOKIA Smart priority switch (accessory) to the LNB socket on the analogue receiver. -
Page 11: Switching On For The First Time With Scart Connections
Switching on for the First Time with SCART Connections • Plug in your Mediamaster • Now you will see the ”Welcome” menu on the screen. • Press OK on the Mediamaster remote control to start the In- stallation procedure. You may now proceed to “First Time Installation.” Tuning Procedure when RF Connections are Used This procedure is necessary only if your Mediamaster is con- nected to the TV with an RF lead. -
Page 12: First Time Installation
FIRST TIME INSTALLATION General Information Once you have correctly connected the Mediamaster, you also have to perform a “First Time Installation.” During this procedure, helpful information is displayed at the bot- tom of the menus. Please note! The OK button always confirms a selection within these menus, and pressing it will take you to the next step in the installation process. -
Page 13: Rf Modulator Type
FIRST TIME INSTALLATION RF Modulator Type If the Mediamaster is connected to the TV with a RF cable, you must select the right RF modulator alternative, which is depend- ent on the country where the Mediamaster is being used. Select “UK (PAL I)” if this is applicable. Select “Other (PAL B/G)”... -
Page 14: Antenna Adjustment And Signal Check
FIRST TIME INSTALLATION Antenna Adjustment and Signal Check Pressing OK from the selected alternative in the previous menu will display the Antenna Adjustment menu (shown to the right) on the screen. For each satellite, (e.g. ASTRA, HOTBIRD, SIRIUS, THOR), up to 4 different channels are preprogrammed and shown in the menu. -
Page 15: Line 1 Through 4 On The Antenna Satellite Selection Menu
FIRST TIME INSTALLATION Line Through on the Antenna Satellite Selection Menu Select one of the alternatives ASTRA, HOTBIRD, SIRIUS or THOR when you have a single LNB pointed towards any of these sat- ellites. Then follow the “Antenna Adjustment and Signal Check” in- structions on the previous page. -
Page 16: Line On The Antenna Satellite Selection Menu
FIRST TIME INSTALLATION Line on the Antenna Satellite Selection Menu This selection is necessary only if your satellite choice differs from the preprogrammed satellite alternatives in the following ways; if you do not use a universal LNB or when you have more than two LNB’s. -
Page 17: Multisatellite/Diseqc Switch Configuration
FIRST TIME INSTALLATION Multisatellite/DiSEqC Switch Configuration Select this alternative if your antenna system has more than one LNB. You can connect up to 4 LNBs. The selection of the different LNBs must be controlled by an external switch. Refer to page 15, “Con- nection of a DiSEqC switch.”... -
Page 18: Channel Search
FIRST TIME INSTALLATION Channel Search The Channel Search procedure can be performed in different ways. • If there are predefined channels, you can make an “Auto- matic” or “Manual Search.” • If no predefined channel is available you can only perform a “Manual Search.”... -
Page 19: Channel Search Progress
FIRST TIME INSTALLATION Channel Search Progress In the Channel Search Progress Menu, you can start searching for digital channels offered by the satellite for which your antenna has been configured. All channels found will be listed in two columns on the screen; with TV channels in one column and Radio channels in the other. -
Page 20: Viewing Mode
VIEWING MODE General Information The following describes the basic functions of your Mediamaster while watching satellite TV or listening to satellite radio. Some of the functions described here are dependent on the Service Provider and can only be used if they are included in the transmitted programme information. -
Page 21: The "I" (Information) Button
VIEWING MODE The “i” (Information) Button The Mediamaster has the ability to display information about pro- grammes currently being broadcast as well as those being broad- cast next. This procedure is the same for both TV and Radio mode. By pressing the “i” button while watching TV you will get a spe- cial Programme Information Banner. -
Page 22: List Of Tv Or Radio Channels
VIEWING MODE List of TV or Radio Channels When viewing TV or listening to radio channels you can access Name of the Indicates a Channel list closed satellite the Channel List by pressing OK. The lists are sorted by satel- lite, network and channel. -
Page 23: Tv Release (0)
VIEWING MODE TV Release (0) With the 0 button you can toggle between analogue terrestrial TV, video, analogue and digital satellite TV signals. (This is only valid if the units are connected via SCART cables, and not by a RF connection.) Video Recording Please note, that during the recording of a programme, every- thing shown on the screen will be registered! For example, if you... -
Page 24: Main Menu
MAIN MENU General Information Many of the functions of the Mediamaster are available from the Main Menu. Press MENU to open it. TV and Radio Channels Please refer to “List of TV and Radio channels” on page 22. Edit Channels From these menus you can create and edit channel lists. - Page 25 MAIN MENU Create list From here you can create your own favourite lists, containing the channels you watch most frequently. You can give each list a spe- cific name, e.g. “Sport” or “Films.” When a favourite list is selected, you see only those channels defined in the list.
- Page 26 MAIN MENU Select Channels From this menu you add and remove the channels in your Favour- ite Lists. You use the “All TV” or “All Radio” list as basis to se- lect the channels from. A channel is added or removed by pressing the OK button. The square to the right on a line will be empty for removed channels, and will contain an “x”...
- Page 27 MAIN MENU Rename Channels Within any of your favourite lists you can rename the channels. Mark the channel you want to rename and press OK. The Re- name dialogue box will then appear and let you modify the ex- isting name. To enter the new name, please follow the instructions under the headline “How to give a specific name”...
- Page 28 MAIN MENU Delete Channels From here, when the “All TV” list is selected in the “Edit Chan- nels” menu, you can delete channels. Please note. Channels deleted this way will be permanently deleted. The only way to get them back is to perform a new channel search.
-
Page 29: System Configuration
MAIN MENU System Configuration You will be asked to enter your access code before you can open this menu. The code is preset to 1234 from the factory. (The code can be changed from the Parental Control menu. Re- fer to page 32.) If you want to customize the system to suit you better, you can specify some settings from the submenus in the “System Con- figuration”... -
Page 30: Tv Settings
MAIN MENU TV Settings From here you can adjust settings concerning your TV. TV screen format Select your TV screen format. The 4:3 format is the standard format for most TV screens. Select 16:9 for a wide screen TV. TV signal If the teletext function does not work when watching channels from an analogue satellite receiver connected to the Media- master, change this setting from RGB to PAL. -
Page 31: Receiver Upgrade
MAIN MENU Receiver Upgrade In order to keep the Mediamaster up-to-date, it will be possible to download new versions of the system software via satellite (THOR) and from the Internet. New software may include new or improved features for existing menus. Enter this menu to check for new software. -
Page 32: Parental Control
1234. DO NOT FORGET IT! Without it you do not have ac- cess to any of the functions where the code is required! If you forget it, you have to contact an Authorized Nokia Service Center to get help. -
Page 33: System Information
MAIN MENU Picture format If you have a TV set with the 4:3 picture format and the transmis- sion is in 16:9, you can select Fullscreen or Letterbox. Fullscreen will fill up the screen but cut off some information on the left and right sides. -
Page 34: Conditional Access
MAIN MENU Conditional Access This menu will only be activated if you have inserted a valid Smart- card in the slot behind the front lid. If more than one CA system is activated, select the one from which you want information. The Viaccess Conditional Access (CA) System is embedded in the Mediamaster. -
Page 35: Glossary Of Terms
GLOSSARY OF TERMS Access Network Authorisation to use the coding system to purchase / A number of digital channels transmitted from one order TV programmes. source. Grouped under separate headings in the chan- nel list. Acquisition Gain Control. Parental control A feature that allows parents to "lock"... -
Page 36: Problem Solving
PROBLEM SOLVING Problem Possible causes What to do The display on the front panel does Mains cable is not connected. Check that the mains cable is not light up/is not lit. plugged into the power socket. No sound or picture, but the front The Mediamaster is in standby Press the standby button or any panel shows the time or - - : - -. -
Page 37: Front Panel Display
PROBLEM SOLVING Problem Possible causes What to do The remote control is not working. Battery exhausted. Change the batteries (both). Remote control is incorrectly Aim the remote control at box. aimed. Check that nothing blocks the front panel. The Mediamaster is in standby Check if (.) is flashing on the front mode. -
Page 38: Technical Specifications
TECHNICAL SPECIFICATIONS Transmission Standards Conditional access system: DVB, MPEG 2 Embedded Viaccess and one PCMCIA interface for a Common Interface CA module LNB / Tuner input (DVB Standard) Connector 1x F-type (LNB) RF input frequency 920-2150 MHz Smartcard Interface: RF input power level -20 to -70 dBm Interface for one card according to ISO 7816 13,5 /18,5 V ±... -
Page 39: Menu Screen Structure
MENUS SCREEN STRUCTURE First time installation Language Antenna/Satellite Selection RF Modulator Channel Search Progress English Antenna with one LNB for ASTRA Antenna Adjustment TV Channels Radio Channels Signal Check Welcome Svenska England Antenna with one LNB for Hotbird 101 CNN Radio Deutsch Other Antenna with one LNB for Sirius... - Page 40 85-265 V 500 mA TV / VCR 50-60 Hz ANTENNA SERIAL TV AERIAL WARNING ! AUDIO DO NOT OPEN – ELECTRICAL SHOCK HAZARD 44 10285 Nokia is a registered trademark of Nokia Corporation http://www.nokia.com 66 76932-10 © 9918 GB 40...