Advertisement
5.Replacement Guide
MAINTENANCE(REPLACEMENT OF LAMP)
WARNING
Disconnect power source before working
on unit.
This is a pin type lamp base and the lamp's
glass is fragile.To remove,pull out carefully.
4W night lamp has threaded base,Remove
by turning counterclockwise.
Make sure the temperature of lens and lighting
unit has cooled down before maintenance
(cleaning) or replacement of lamp.
CAUTION
Remove dust and dirt from light kit cover
assembly and lens, before replace the lamps.
1. Remove grille by pulling down one mounting spring. Then
pull down the other mounting spring. (Squeeze mounting
spring and pull down carefully) (Fig.1)
2. Remove the screw as shown in step 1 of (Fig.2)
Remove the light kit cover assembly as shown in step 2 of (Fig.2)
3. Remove the fluorescent lamps (Maxlite MLS13GU35,13W)
and night lamp as shown in step 1 ,step 2 and step 3 of (Fig.3)
4. Install new night lamp (MAX 4W incandescent lamp) and
new fluorescent lamps (Maxlite MLS13GU35,13W) as
shown in step 1 ,step 2 and step 3 of (Fig.4)
5.Install light kit cover assembly.(Fig.5)
Ceiling
Plug connector
lighting unit
Gloves
Rib
Claw
Insert Plug connector
Remove screw
Light kit cover
(M4X8)
assembly
Lens
Fluorescent
lamp
Fluorescent
lamp
3
Light kit cover
assembly
Grille
Fig.1
Fig.2
3
Night lamp
Fig.3
Night lamp
Fig.4
Secure screw
(M4X8)
Fig.5
10
Advertisement
