Garage Door Opener; Programming The Homelink - Toyota AVALON 2005 Manual

Garage door opener

The garage door opener (
Universal Transceiver) is manufactured
R
under license from HomeLink and can
be programmed to operate garage
doors, gates, entry doors, door locks,
home lighting systems, and security
systems, etc.
248
'05 AVALON_U (L/O 0501)
(a) Programming the HomeLink
R
The HomeLink in your vehicle has 3
buttons and you can store one program
for each button.
To ensure correct programming into the
R
HomeLink , install a new battery in the
hand- held transmitter prior to program-
ming.
The battery side of the hand- held trans-
mitter must be pointed away from the
R
HomeLink during the programming pro-
cess.
For Canadian users, follow the procedure
R
in "Programming an entrance gate/Pro-
gramming all devices in the Canadian
market".
1. Decide which of 3 HomeLink
you want to program.
2. Place your hand- held garage transmit-
ter 25 to 75 mm (1 to 3 in.) away from
R
the surface of the HomeLink
Keep the indicator light on the HomeLink
in view while programming.
3. Simultaneously press and
hand- held garage transmitter
along with the selected HomeLink
ton.
I n f o r ma t i o n P r o v i d e d b y :
R
4. When the indicator
R
HomeLink changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
5. Test the operation of the HomeLink
pressing the newly programmed button.
If programming a garage door opener,
check to see if the garage door opens
and closes.
If the garage door does not operate, iden-
tify if your garage transmitter is of the
"Rolling Code" type. Press and hold the
R
programmed HomeLink
rage door has the rolling code feature if
the indicator light (on the HomeLink
flashes rapidly and then remains lit after
2 seconds. If your garage transmitter is
R
buttons the "Rolling Code" type, proceed to the
heading "Programming a rolling code sys-
tem".
6. Repeat steps 2 through 5 for each re-
R
.
maining HomeLink
R another device.
hold the
button
R
but-
2005 AVALON from Jan. '05 Prod. (OM41408U)
light on the
R
by
button. The ga-
R
)
button to program