Description - Echo CS-2510TES Operator's Manual

1. Front hand guard - Guard between the front handle and
the saw chain for protecting the hand from injuries and
aiding in control of the chain saw if the hand slips off the
handle.
This guard is used to activate the chain brake which is to
stop the saw chain rotation.
2. Rear handle (for the right hand) - Support handle
located on the top of the engine housing.
3. Choke control knob - Device for enriching the fuel / air
mixture in the carburettor to aid cold starting.
4. Silencer cover - Cover the silencer not to make operator
touch to hot surface of silencer.
5. Safety decal - Part number X505-007710
6. Chain tension adjuster - Device to adjust chain tension.
7. Clutch cover - Protective cover to the guide bar, saw
chain, clutch and sprocket when the chain saw is in use.
8. Chain catcher - A projection designed to reduce the risk
of the operator's right hand from being hit by a chain
which has broken or derailed from the guide bar during
cutting.
9. Guide bar - The part that supports and guides the saw
chain.
10. Chain - Chain, serving as a cutting tool.
11. Front handle (for the left hand) - Support handle
located at the left side of the engine housing.
12. Fuel tank cap - For closing the fuel tank.
13. Oil tank cap - For closing the oil tank.

Description

14. Starter handle - The grip of the starter, for starting the
engine. "ES" START
15. Spark plug cover - Covers spark plug.
16. Spark plug cover latch - Device for installing the spark
plug cover.
17. Cleaner cover latch - Device for installing the air cleaner
cover.
18. Air cleaner cover - Covers air filter.
19. Purge bulb (primer pump) - When starting engine, push
primer pump 3 or 4 times.
20. Safety decal - Part number X505-008600
21. Throttle trigger - Device activated by the operator's
finger, for controlling the engine speed.
22. Throttle trigger lockout - A safety lever which must be
depressed before the throttle trigger can be activated in
order to prevent the accidental operation of the throttle
trigger.
23. Ignition switch - Device for connecting and
disconnecting the ignition system and thus allowing the
engine to be started or stopped.
24. Lifting hook - If working off the ground the operator must
be trained in safe climbing techniques and use of all
recommended safety equipment.
25. Operator's manual - Included with unit.
Read before operation and keep for future reference to
learn proper, safe operating techniques.
26. Tools - 13 x 16 mm T-wrench (combination screwdriver
/ spark plug socket) and L-wrench.
27. Guide bar cover - Device for covering the guide bar and
saw chain during transport and other times when the
chain saw is not in use.
14