Others; Part Names - Pioneer VSX-LX301 Basic Manual

> Before start > Hookup

Others

Listening To the Radio
a
1. Press TUNER (a) on the remote controller repeatedly to
2. Press MODE (c) on the remote controller, so that the
b
3. When you press the
You can preset up to 40 stations.
1. Tune into the AM/FM radio station you want to register.
2. Press +Fav (d) on the remote controller so that the
3. While the preset number is flashing (about 8 seconds),
c
d
4. Press +Fav (d) again on the remote controller to register
e
0 To delete a preset station, press the  /
Frequency step setting
Press the
"System Setup" – "Miscellaneous" – "Tuner" – "AM/FM
Frequency Step" and select the frequency step for your
area. Note that when this setting is changed, all radio
presets are deleted.
24
> Setup
select either "AM" or "FM" on the display.
"TunMode: Auto" is displayed on the display.
/ cursor (b) buttons on the
remote controller, automatic tuning starts, and searching
stops when a station is found. When tuned into a radio
station, the "TUNED" indicator on the display lights.
preset number on the display flashes.
repeatedly press the  / cursor (b) buttons on the
remote controller to select a number between 1 and 40.
the station. When registered, the preset number stops
flashing. To select a preset radio station, press the  /
cursor (b) buttons on the remote controller.
buttons on the remote controller to select the preset
number you want to delete, press +Fav (d) on the
remote controller and then press CLEAR (e) while the
preset number is flashing. When deleted, the number on
the display goes off.
button on the remote controller to select
> Playback > Part Names
d
e
b
c
a
cursor (b)
Multi-zone
If you haven't made the Multi Zone settings ( P20) in
Initial Setup, change the settings according to the audio
output method to the separate room (ZONE 2). Press the
button on the remote controller and make the settings
in System Setup accessed from the Home screen that is
displayed. If you have connected speakers in a separate
room with speaker cable, select "Zone 2" in "System
Setup" − "Speaker" − "Configuration" − "Zone Speaker".
If you have connected a power amplifier in a separate
room with an analog audio cable, then set "System Setup"
− "Multi Zone" − "Zone 2" − "Output Level" to "Variable"
if you want to be able to adjust the volume on this unit.
Play
1. While holding down MODE (a) on the remote controller,
press ZONE 2 (b) for 3 or more seconds until the remote
indicator blinks twice.
0 The remote controller switches to the mode for
controlling ZONE 2.
To return the remote controller to main room control
mode: While holding down MODE (a) on the remote
controller, press MAIN (c) for 3 seconds or more until the
remote indicator flashes once.
2. Point the remote controller at the main unit and press Í
(d).
"Z2" lights on the main unit display.
3. Press the input selector button (e) of the input to be
played in the separate room. On the main unit, after
pressing ZONE 2-CONTROL, within 8 seconds turn the
input selector dial to select the input to be played in the
separate room.
0 You can only select the same inputs for the main
room and separate room with the "NET" or