1. Manuals
  2. Brands
  3. SoundPeak Manuals
  4. Amplifier
  5. SP-6K DFR
  6. Owner's manual

SoundPeak SP-6K DFR Owner's Manual

Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
OWNER'S MANUAL
CLASS D MONO CHANNEL
FULL RANGE AMPLIFIER
FAN COOLING SYSTEM
SP-6K DFR
SP-8K DFR
SP-12K DFR
MADE IN KOREA
Manual size : 150 x 210mm

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SP-6K DFR and is the answer not in the manual?

Questions and answers

Related Manuals for SoundPeak SP-6K DFR

Summary of Contents for SoundPeak SP-6K DFR

  • Page 1 OWNER'S MANUAL CLASS D MONO CHANNEL FULL RANGE AMPLIFIER FAN COOLING SYSTEM SP-6K DFR SP-8K DFR SP-12K DFR MADE IN KOREA Manual size : 150 x 210mm...

  • Page 2: Installation

    Installation In case you install the amplifier by yourself, please read the user manual carefully and follow the outlined instructions. Mounting Preparation Disconnect the negative (-) battery cable before mounting or making any connections. Check the battery and alternator ground (-) connections. Make sure they are properly connected and free of corrosion.

  • Page 3: Panel Layout

    Panel Layout (SP-6K DFR / SP-8K DFR / SP-12K DFR) SPEAKER BASS INPUT INPUT OUTPUT REMOTE GAIN FREQ. FREQ. BOOST MODE CLIP 10Hz 100Hz 50Hz 1.5KHz 12dB HIGH 50Hz 500Hz 500Hz 15KHz LEFT RIGHT 1) INPUT Connect preamp signal cables from head unit to RCA input of amplifier.
  • Page 4 +12V(B+), GND, REM (SP-6K DFR / SP-8K DFR / SP-12K DFR) +12V POWER INPUT GND (GROUND CONNECTION) For connection to chassis ground. For optimum performance, 0 gauge cable is recommended. REM (REMOTE) Connect to switched +12V from the head unit.

  • Page 5: Speaker Connection

    +12V ), GND, REM Connection (SP-6K DFR / SP-8K DFR / SP-12K DFR) +12V POWER INPUT GROUND Remote turn on HEAD UNIT Recommend fuse rating (See the page 8) 12V BATTERY This drawing is for illustration purposes only! We recommend using 12 AWG speaker cables to obtain increased performance.

  • Page 6: Troubleshooting

    Troubleshooting Assure that the Power LED is on, if so please proceed with step # 3, if not, continue with the steps below; 1. Check the in line fuse (s) on the battery’s positive cable, replace if needed. 2. Assure that the Ground is properly attached to the vehicle’s chassis on a clean metal point, tighten or grind the connection point once again.

  • Page 7: Specifications

    Specifications MODEL CODE SP-6K DFR SP-8K DFR Continuous power output -RMS power, 1 ohm mono @12.6V : 3000W x 1CH : 5000W x 1CH : 3600W x 1CH : 6000W x 1CH -RMS power, 1 ohm mono @13.8V : 3800W x 1CH...
  • Page 8 MADE IN KOREA...

This manual is also suitable for:

Sp-8k dfrSp-12k dfr

Table of Contents