Troubleshooting - Fellowes POWERSHRED HD-10Cs Instructions Manual

BASIC SHREDDING OPERATION
Continuous operation:
5-minute maximum
NOTE: Shredder runs briefly after each pass
to clear entry. Continuous operation beyond
5-minutes will trigger 20-minute cool
down period.
ADVANCED PRODUCT FEATURES
SAFESENSE TECHNOLOGY OPERATION
®
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
1 2
Turn the shredder
Touch test area and
ON ( )to activate look for the SafeSense
SafeSense
indicator to illuminate
®
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
PRODUCT MAINTENANCE
OILING SHREDDER
machine may experience diminished sheet capacity, intrusive noise when
shredding and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
Set to Off (O) *Apply oil across entry
* Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250

TROUBLESHOOTING

PAPER JAM
1 2
Press and hold Alternate slowly back and forth
Reverse (R)
2-3 seconds
ATTENTION: If the SafeSense ® light remains on, you must engage the
Once the jam is cleared, reset the SafeSense
PAPER/CARD
2
1
Press Auto-On ( )
Plug in and put disconnect
power switch in ON (I) position
3
H D - 1 0 c
s
10
SafeSense is active
®
and working properly
®
3
Press and hold Reverse
(R) 2-3 seconds
4
3
Set to Off
and unplug
® feature. (See SafeSense ® instructions below.)
3
Feed paper/card
straight into paper
entry and release
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the
sensors may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1 2
Set to Off (O) Locate Auto-start
and unplug infrared sensor
5 6
Gently pull uncut Set to Auto-On ( )
paper from paper
and resume shredding
entry. Plug in
Override Switch in order to perform steps above.
4
When finished shredding,
set to Off
.
3 4
Dip cotton swab in
rubbing alcohol away any contamination
from the paper sensors
Shredder doesn't start:
Yellow - SafeSense ® active
Yellow flashing - SafeSense
Wait 20 minutes for motor to cool down
Make sure head is on basket correctly
Remove and empty basket
® not active
3