CHECKING FLOW
Check R513, R514, C512
Check whether Ant SW
Set as TX mode
Refer to Graph 4.3.2
Refer to Table 4.3.2
Check RF Level of
U502.27(for GSM850 & EGSM),
U502.29(for DCS&PCS)
Check SW501. ANT, RF
with RF Cable connected.
Check SW501.ANT,RF
with RF Cable disconnected.
LGE Internal Use Only
Copyright © 2009 LG Electronics. Inc. All right reserved.
Only for training and service purposes
For the test,
TX Stand alone Mode is needed. Refer to chapter
10 (PL=7 for EGSM&GSM850, PL=2 for DCS&PCS)
Check PA_EN, ANT_SW1 &
VBAT
Yes
Pin15 : ~29.5dBm
Pin10 : ~26.5dBm
Yes
Open
Yes
Short
Yes
END
- 79 -
4. TROUBLE SHOOTING
No
Changing board
Go to 4.3.3 Checking PAM control
No
signal
No
Changing SW501
No
Changing SW501
Table 4.3.1
LGE Internal Use Only