Polaris RZR XP 1000 EPS High Lifter Edition Owner's Manual page 130

MAINTENANCE
Cleaning and Storage
Storage Tips
Inspect and Lubricate
Inspect all cables and lubricate all areas of the vehicle as recommended
in the Periodic Maintenance Chart beginning on page 79.
Fog the Engine
1. Treat the fuel system with POLARIS Carbon Clean or other
equivalent fuel treatment. Follow the instructions on the container.
Start the engine. Allow it to idle for several minutes so the Carbon
Clean reaches the injectors. Stop the engine.
2. Remove the spark plugs and add 2-3 tablespoons of engine oil. To
access the plug holes, use a section of clear 1/4" hose and a small
plastic squeeze bottle filled with the pre-measured amount of oil.
Do this carefully! If you miss the plug holes, oil will drain from the
spark plug cavities into the hole at the front of the cylinder head,
and appear to be an oil leak.
3. Reinstall the spark plugs. Torque to specification. See page 95.
4. Apply dielectric grease to the inside of each spark plug cap. Do not
reinstall the caps onto the plugs at this step.
5. Turn the engine over several times. Oil will be forced in and around
the piston rings and ring lands, coating the cylinder with a protec-
tive film of fresh oil.
6. If POLARIS fuel system additive is not used, fuel tank, fuel lines,
and injectors should be completely drained of gasoline.
7. Reinstall the spark plug caps to the spark plugs.
Battery Maintenance
See pages 122-124 for storage and charging procedures.
Storage Area/Covers
Be sure the storage area is well ventilated. Cover the vehicle with a
genuine POLARIS cover. Do not use plastic or coated materials. They
do not allow enough ventilation to prevent condensation, and may
promote corrosion and oxidation.
128