Table of Contents
Advertisement
Brake Adjustment
Adjust the brake tension by first using the barrel adjuster on the rear of the brake. Turn counterclockwise to loosen.
Once proper tension is set tighten the lock nut clockwise to prevent barrel adjuster from moving. New bikes may
require a week of use to sync the parts into perfect specification. Please allow this period of use before any
adjustments are made.
E.)
If the brake is too tight (wheel not spinning freely) you will need to turn the barrel adjuster clockwise (towards the
rear of the bike.)
Adjust the brake cable by loosening nut on the banjo bolt slightly so that you are able to pull the cable through and
retighten the nut.
Banjo Bolt
Adjusting the Foot Pegs
The foot pegs can either be parallel or perpendicular to the bike during use. To adjust the pegs, simply depress silver
tab and turn until tab falls into the appropriate hole.
Advertisement
Table of Contents
