LawnMaster CLGS1832A01_V1 Operator's Manual page 7

SAFETY WARNINGS
Do not use the charger if it has been subjected to a heavy knock, dropped or otherwise damaged
in any way. Have the charger checked and repaired by an authorised service centre.
Do not disassemble the charger. Incorrect re-assembly may result in the risk of fire, electric
shock or electrocution.
Disconnect the charger from the power supply before attempting to clean it to reduce the risk
of an electric shock. Removing the battery pack alone does not reduce the risk.
Battery Pack Safety Warnings
Do not attempt to charge the battery pack with any other charger than the one supplied.
The charger and battery pack supplied with it are specifically designed to work together.
Charge and store the battery pack in an ambient temperature of 18 - 24°C (65 - 75°F) to ensure
the longest battery life and best performance. Do not charge or store the battery pack in
temperatures below 0°C (32 °F) and above 40°C (104 °F).
Small leakage of liquid from the battery pack may occur under extreme usage or temperature
conditions. However, if the outer seal is broken and this leakage comes into contact with your
skin wash the affected area quickly with water. If the leakage gets in your eyes flush your eyes
with clean water for a minimum of 10 minutes and seek immediate medical attention.
Never attempt to open the battery pack for any reason. If the plastic housing of the battery pack
breaks open or cracks, immediately discontinue its use and do not recharge it.
Do not store or carry a spare battery pack in a pocket or toolbox or any other place where it may
come into contact with metal objects. The battery pack may be short-circuited causing damage
to the battery pack, burns or a fire.
Do not pierce the battery with nails, strike the battery with a hammer, step on the battery or
otherwise subject it to strong impacts or shocks.
Protect the battery pack against heat. Do not place the battery in direct sunlight or use or store
the battery inside cars in hot weather. Doing so may cause the battery to generate heat,
explode or ignite.
Never try to charge a battery pack that is cracked or damaged in any other way. There is a
danger of electric shock or electrocution.
Only charge the battery pack with the charger supplied.
Vibration And Noise Reduction
To reduce the impact of noise and vibration emission, limit the time of operation, use low-vibration and
low-noise operating modes as well as wear personal protective equipment.
Take the following points into account to minimize the vibration and noise exposure risks:
Only use the product as intended by its design and these instructions.
Ensure that the product is in good condition and well maintained.
e correct cutting attachments for the product and ensure they in good condition.
Keep tight grip on the handles/grip surface.
Plan your work schedule to spread any high vibration tool use across a longer period of time.
7