Troubleshooting - Zanussi ZDT12002 User Manual

Troubleshooting

The appliance does not start or it stops during operation.
First try to find a solution to the problem (refer to the ta-
ble). If not, contact the Service.
Alarm code
• The indicator of the set programme flashes continu-
ously.
• The end indicator flashes 1 time intermittently.
• The indicator of the set programme flashes continu-
ously.
• The end indicator flashes 2 times intermittently.
• The indicator of the set programme flashes continu-
ously.
• The end indicator flashes 3 times intermittently.
Warning! Deactivate the appliance before you make
the checks.
Problem
The programme does not
start.
The appliance does not fill
with water.
The appliance does not drain
the water.
24
Possible cause
The mains plug is not connected in the
mains socket.
The appliance door is open.
The fuse in the fuse box is damaged.
The water tap is closed.
The water pressure is too low.
The water tap is clogged or there is lime-
scale on it.
The filter in the water inlet hose is clog-
ged.
The water inlet hose has a kink or a
bend.
The anti-flood device is on. There are
water leakages in the appliance.
The sink spigot is clogged.
The water drain hose has a kink or a
bend.
With some problems, some indicators flash continuously
and/or intermittently at the same time to show an alarm
code.
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
Connect the mains plug.
Close the appliance door.
Replace the fuse.
Open the water tap.
Contact your local water authority.
Clean the water tap.
Clean the filter.
Make sure that the position of the hose is
correct.
Close the water tap and contact the Serv-
ice.
Clean the sink spigot.
Make sure that the position of the hose is
correct.
Problem
Possible solution