Using The 3D Glasses - Optoma HD33 User Manual

Using the 3D glasses

N
OTE
1. To turn ON 3D glasses: Press the "Power" button and the LED will flash
For more detailed
information,
please refer to
2. Verify that 3D content is being sent to the projector and signal is compat-
3D glasses user's
guide.
3. Turn on the "3D Mode" (DLP-Link/VESA 3D - depending on which type
4. Turn on 3D glasses and verify image appears in 3D without eyestrain.
5. If the image does not appear in 3D, please check 3D device set up well
6. To use projector's "3D Sync-Invert" option to optimize your 3D experience.
7. To turn OFF 3D glasses: Press the "Power" button and hold until the LED
8. For more detailed information, please refer to the 3D glasses user's
one time indicating the glasses are ready to use 3D mode.
ible with projector specifications.
of glasses you are using) of the 3D projector. The option is located in the
"Display" section of the projector OSD menu.
to send out 3D image or not. Or "SBS Mode" should turn on when input
signal is 2D 1080i side-by-side and repeat previous steps 1 ~ 4.
The option is located in the "Display" section of the projector OSD menu.
switches off.
guide, or manufacturer's Website.
Installation
15
English