Pioneer VSX-908RDS Service Manual page 93

QQ
3 7 63 1515 0
8. PANEL FACILITIES AND SPECIFICATIONS
8.1 PANEL FACILITIES
Front Section
All the controls on the front panel are explained and/or referenced here. To open the front panel push gently on the lower third of the
panel.
1 2
STANDBY/ON
—OFF _ON
TE
L 13942296513
∞
1 Main power (— ON/ _ OFF) button
If the button is OFF (_), the power of the receiver is shut off
and the STANDBY/ON button (2) on the receiver or the
remote control do not function. Pressing the button again
will turn the receiver ON (—) and the receiver enters the
standby mode. In the standby mode, you can turn on the
receiver using the STANDBY/ON button (2) on the receiver
or the remote control.
2
STANDBY/ON button
Press to switch the receiver ON or into the STANDBY
mode.
3 STANDBY indicator
Lights when the receiver is in the STANDBY mode. (Please
note that this receiver consumes a small amount of power
(1.0 W) during the standby mode.)
4 DSP MODE button
www
Press repeatedly to select a DSP sound mode. (HALL 1,
HALL 2, JAZZ, DANCE, THEATER 1, or THEATER 2). Use
these modes to produce surround sound from standard (two
channel) stereo sources and create different listening
.
environments.
http://www.xiaoyu163.com
3 4 5 6
AUDIO/VIDEO MULTI-CHANNEL RECEIVER
DSP
STANDBY MODE STEREO
/DTS
THX CINEMA ADVANCED STANDARD
MPEG
~ ! @ # $ % ^
5-CHANNEL EQUAL POWER OUTPUT EXTERNAL
DECODER IN DIRECT
VIDEO INPUT
S-VIDEO VIDEO L AUDIO R
PHONES
SPEAKERS
¢ £
x ao u163
y
i
http://www.xiaoyu163.com
VSX-908RDS, VSX-908RDS-G
2 9
8
7 8 9 0
Q Q
3 6 7 1 3 1 5
DIGITAL
SIGNAL
LOUDNESS MIDNIGHT NR SELECT
– BASS + – TREBLE + INPUT ATT MONITOR
™ ¡ +
5 STEREO button
Press to select the STEREO sound mode. In this mode,
sound comes from the front (left and right) speakers only.
6 2/DTS buttons
THX CINEMA : Press to select the HOME THX CINEMA
mode when listening to Dolby Digital, Dolby Pro Logic, DTS,
or a variety of other sources.
ADVANCED : Press to select one of the four Advanced
Theater modes.
STANDARD (
MPEG
STANDARD or MPEG mode.
7 Display
8 Remote sensor
Point the remote control toward the remote sensor to
operate the receiver.
9 EON MODE button/indicator
co
Press to select the EON mode in the FM mode. The
indicator lights when the EON mode is selected.
.
0 FL DIMMER button
Use to adjust the brightness of the main display.
9 4 2 8
-
INPUT
SELECTOR
EON
MODE
FL
DIMMER
MASTER
VOLUME
DOWN UP
&
0 5 8 2 9 9 4 2 8
RF ATT CLASS FM/AM – TUNING +
TAPE 2 CHARACTER
/SEARCH MEMORY – STATION +
_ ) ( *
) : Press repeatedly to select the
m
9 9
=
9 9
93