Advance Planning; Accessories - GE UNC15NJ-II Owner's Manual And Installation Instructions

ADVANCE PLANNING (Cont)
Installation Notes
A drain pump is available for this ice machine. The drain
pump kit number is UPK3 and is available at
www.GEApplianceparts.com or by calling 877-959-8688.
In Canada visit www.GEAppliances.ca or call 800.561.3344.
Built-In Installation: If a finished floor is to be installed in
the area after the ice machine has been built in, shims the
expected thickness of the floor should be installed under the
unit to keep the machine level with the planned floor level.
NOTE: The water connection is at the back and adds a few
inches to the cabinet depth.
Installation on a slab: You will need to install a drain
pump to the appliance and pump the water to the point
of drainage. See Accessories. Pumps will pump 1 story (10
feet) hight.
Installation over a crawl space or basement: Either
a gravity drain or a pump may be used. For pump, see
Accessories. If there is not enough room behind the
machine for a drain/waste receptacle, the drain will have to
be below the floor.
NOTE: When installed in a corner, the door swing may be
limited due to handle contact with the wall or cabinet face.
A water supply is required. Water supplies vary in the
degree of mineral content. High mineral content water will
require more frequent maintenance. Water filtration may
improve the taste of the ice as well as cut down on some of
the mineral build up.
Installation Instructions

ACCESSORIES

Finished stainless steel door panels with handles are
available from GE Appliances for attachment to the ice
machine.The panel kits are:
• ZIP80SS - Stainless steel door with Euro Style Handles
• PIP70SS - Stainless steel door with Profile Style Handles
To order, go to www.GEApplianceParts.com or call
877-959-8688. In Canada visit www.GEAppliances.ca or
call 800.561.3344.
Kickplate Extension: In some situations the leg levelers
will be extended enough to become visible. A kit to extend
the kickplate over the legs is available. That kit number is
WR02X25798. To order, go to www.GEApplianceParts.
com or call 877-959-8688. In Canada visit
www.GEAppliances.ca or call 800.561.3344.
Cabinet Stability: In some free standing installations it
may be prudent to add an anti-tip bracket that secures
the back of the cabinet to a wall. That kit number is
WR01X25709. To order, go to www.GEApplianceParts.com
or call 877-959-8688. In Canada visit
www.GEAppliances.ca or call 800.561.3344.
Drain Conversion: A gravity drain model can be
converted to a drain pump model by installing a drain
pump kit. The drain pump kit consists of a drain pump,
wiring harness and associated tubing. The part number is
UPK3. To order, go to www.GEApplianceParts.com or call
877-959-8688. In Canada visit www.GEAppliances.ca or
call 800.561.3344.
11