Scope Of Delivery; Intended Use - Waeco PerfectView Accessory VS200 Instruction Manual

_VS200.book Seite 19 Montag, 26. Januar 2009 2:35 14
PerfectView
When the negative terminal of the battery is disconnected, all data stored in the volatile
memory will be lost.
The following data must be reset, depending on the vehicle equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the operating manual.
Observe the following instructions when working with electrical parts:
When testing the voltage in electrical cables, only use a diode test lamp (fig. 1 1,
page 3) or a voltmeter (fig. 1 2, page 3).
Test lamps with an illuminant (fig. 1 3, page 3) take up voltages which are too high
and which can damage the vehicle's electronic system.
When making electrical connections, ensure that:
– They are not kinked or twisted
– They do not rub on edges
– They are not laid through sharp-edged ducts without protection (fig. 2, page 3).
Insulate all connections.
Protect the cables from mechanical wear (for example rubbing against existing cables)
using cable binders or insulating tape.
3

Scope of delivery

No. in
Quantity Designation
fig. 3, page 4
1
2
3
4
–
4

Intended use

PerfectView VS200 (item no. 9102200011) is a video splitter. One or two cameras can be
connected to a monitor using the VS200.
1 Video splitter
1 Connection cable for vehicle electrics
1 Switch for manually activating the cameras
1 Connecting cables for video splitter –
monitor
1 Installation material
Scope of delivery
Item no.
9102200011
19