Table of Contents
Advertisement
Available languages
Available languages
Quick Links
BLUETOOTH
CLIP-ON EARSET
Overview
1. Earphone
2. Charger socket
3. Indicator LED
4. Answer/End button
5. Microphone
6. Volume +
7. Volume -
Note!
Please fully charge headset before fi rst use.
Using the device
Charging – internal ringer will sound three
short beeps continuously when battery is low.
TO start charging plug one end of USB cable to
the charger socket of MT3535, other end plug to
the USB power supply. Red LED indicator is on
when charging in progress, red LED is off when
rechargeable battery is full.
Power ON – to power ON press and hold an-
swer/end button for 2 seconds until LED indi-
cator starts to fl ash red blue. Internal ringer will
sound three short beeps.
Power OFF – to power OFF press and hold an-
swer/end button for about 5 seconds until LED
indicator is off . Internal ringer will sound three
short beeps.
Pairing the device – turn on device in standby
mode. Seek for new Bluetooth devices in your
mobile phone, when prompted enter passcode
0000. You only need to pair device once. If pair-
ing is successful blue LED indicator start to blink.
Answer call – when you receive an incoming
call, you will hear ringing in the headset, press
answer/end button once.
End call - during conversation press answer/end
button once.
Reject call – when you receive an incoming call
press and hold answer/end button for at least 1
seconds to reject a call.
Redial last number – when in standby mode,
press shortly answer/end button twice.
Voice dialing – your mobile phone must sup-
port voice dialing. When in standby mode press
answer/end button until you hear a prompt –
then say name from phonebook. Best result are
when voice dialing records are made through
MT3535 headset. Follow mobile phone user's
manual for more details.
Volume Up – during music playback press once
to increase volume, when the highest level is
reached you will hear two beeps.
Volume Down – during music playback press
once to decrease volume, when the lowest level
is reached you will hear two beeps.
MT3535
User's manual
EN
Advertisement
Table of Contents
Related Manuals for media-tech MT3535
Summary of Contents for media-tech MT3535
- Page 1 TO start charging plug one end of USB cable to once to decrease volume, when the lowest level the charger socket of MT3535, other end plug to is reached you will hear two beeps. the USB power supply. Red LED indicator is on when charging in progress, red LED is off when rechargeable battery is full.
- Page 2 – jeden koniec kabla USB podłącz do gniazda Najlepsze rezultaty są, gdy nagrania w książce telefonicznej dokonywane są poprzez zestaw ładowarki MT3535, drugi koniec kabla podłącz do źródła zasilania USB. Podczas ładowania dio- MT3535. Więcej informacji znajdziesz w instruk- cji obsługi telefonu komórkowego.
- Page 3 Sie das USB Kabel in den Stromanschluss von Sie ein Signal hören – daraufhin nennen Sie den MT3535 an und das andere Ende in das USB-La- Namen aus Ihrem Telefonspeicher, den Sie anru- degerät. Eine rote LED wird beim Ladevorgang fen möchten.
- Page 4 MT3535 BLUETOOTH CLIP-ON EARSET Ръководство за употреба Преглед не/прекратяване на разговор за 5 секунди, докато LED индикатора изгасне. Вградения зумер ще направи три кратки бипвания. Свързване на устройството – включете устройството в стендбай режим. Потърсете нови Bluetooth устройства от вашия мобилен...
- Page 5 USB kes en gang for at øge volumen, når det højeste kablet til MT3535´s oplader stik, og den anden niveau er nået, vil du høre to bip. ende til USB strømforsyning. Rød LED indikator er tændt, når opladningen er i gang, røde LED er...
- Page 6 2 x pisk. ja vključite en konec USB kabla na polnilni vtič od MT3535,drug konec kabla pa na USB polnilno napravo.Rdeča lučka sveti ko se naprava polni. Rdeča lučka se ugasne ,ko je naprava napolnje- Vklop –...
Need help?
Do you have a question about the MT3535 and is the answer not in the manual?
Questions and answers