Philips SRP4004/86 User Manual page 12

The remote control does not wake up anymore.
Battery level too low or battery lifetime came to an end.
• R eplace the batteries. See chapter 2.1.
The device I want to operate does not respond at all /
does not respond to all of the key commands.
• C heck if the keys you press are available on the original
• T ry improving keys. See chapter 2.3.2.
Wrong code selected during setup.
• S et up the remote control again for the device. Always
It may be that the keys that you are trying to use have a
different naming on the original remote control.
• T ry out all keys to find the one(s) you need.
The Teletext keys do not work.
• Find out whether your TV is equipped with Teletext.
• T ry improving the Teletext keys. See chapter 2.3.2.
• C heck whether you are using the correct keys to switch
Will my settings be deleted when I replace the batteries?
No. All user settings will be retained in the remote control
memory during battery replacement.
12
SRP4004_86_Manual.indd 12
Operation
remote control of the device.
test if the device responds, before leaving setup mode.
See chapter 2.2.
on Teletext. For TV this is the
key.
Batteries
EN
key; for STB this is the
28-05-09 18:17