Door Alignment - Haier HA10TG31SS User Manual

DOOR ALIGNMENT

FREEZER DOOR
1. Remove hinge cover screw. (Fig. 1)
2. Remove the top hinge cover.
3. Loosen the top hinge screws using a Phillips
head screwdriver.
4. Adjust the door or put a spacer in between and
then tighten the screws.
5. Replace the top hinge cover.
Hinge
cover
Fig. 1
REVERSING THE DOOR SWING
Left/right door opening method:
This product allows you to reverse the door
opening from left to right and back. You can select
your preference of door opening by following the
procedure to make the change.
Dismantling: (see g. 1 and g. 2)
1. A x refrigerator and freezer door by sticking
adhesive tape on both sides to hold doors in
place.
2. As shown in g. 1, dismantle the hinge cover
on the upper part of freezer door with a Phillips
head screwdriver. Then remove the three
screws that hold the hinge. Take out the hinge
by pulling it vertically, and keep it in a safe place.
3. Remove the adhesive tape on freezer door, lift it
and take o the door, and carefully put it aside.
4. Dismantle two screws of the central hinge, lift it
and take o the central hinge, and keep them in
a safe place. (see g. 2)
5. Remove the adhesive tape on refrigerator door,
lift it and take refrigerator door, and carefully
put it aside.
6. Remove the doorstoppers from the refrigerator
and freezer doors.
7. Insert left side doorstopper (provided in your
packing) on the left side bottom hole of the
refrigerator door and on the left side bottom
hole of the freezer door. Fasten with screws
provided.
Top hinge
screw holes
central hinge
PAGE 8 SET UP & USE
Fig. 2
doorstopper (right side)
middle pivot pin