Change Lan Settings - TP-Link RE450 User Manual

Chapter 3
¾ To enable or disable the extended network:
1. Go to Settings > Wireless
2. The wireless radio is enabled by default. If you want to disable the wireless function
of a certain band, just clear the
of this band will be invalid.
¾ To change the wireless network name (SSID):
1. Go to Settings > Wireless
2. Create a new SSID in
sensitive.
Note:
If you change the wireless settings via a wireless device, you will be disconnected after the settings are applied.
Please write down the new SSID for future use.
¾ To hide the SSID of the extended network:
1. Go to Settings > Wireless
2. Select Hide SSID broadcast, and the corresponding SSID will not display when you
scan for local wireless networks on your wireless device and you have to manually
join the network.
3. 3.

Change LAN Settings

The extender is preset with a default LAN IP 192.168.0.254, with which you can log in to
the web management page. The LAN IP address, together with the Subnet Mask, also
defines the subnet that the connected devices are on. If the IP address conflicts with
another device on your local network or your network requires a specific IP subnet, you
can change it.
1. Visit http://tplinkrepeater.net, and log in with the username and password you set for
the extender.
2. Go to Settings > Network.
3. Select Use the following IP
4. Enter a new IP Address as needed and leave the
and enter the gateway that is in the same subnet as the IP address. The gateway is
usually the LAN IP address of your extender.
> Extended Network.
Enable checkbox. In this case, all the wireless settings
> Extended Network.
Extended 2.4GHz SSID
> Extended Network.
address.
Customize Your Network
or click Copy Host SSID. The value is case-
Subnet Mask as the default settings
15