Table of Contents
Advertisement
Available languages
Available languages
PREPARING TO USE
UNPACKING AND SET UP
•
Carefully remove the unit from the display carton and remove all packing materials from the
unit.
•
Unwind the AC power cord and extend it to its full lenght.
•
Unwind the FM Antenna wire and extend it to its full lenght.
•
Place the unit on stable, level surface, convenient to an AC outlet, out of
direct sunlight, and away from sources of excess heat, dust, moisture,
humidity or strong magnetic fields.
•
Open the CD door. Lift the CD diskette cover, remove the transit cards
which was used to secure the laser during shipment and dispose of this
card.
•
Connect the plug to your AC outlet.
POWER SOURCE
This system is designed to operate on normal 230V 50Hz AC only. Attempting to operate this
system from any other power source may cause damage to the system and such damage is not
covered by your warranty.
IMPORTANT: Raising and lowering the CD door
•
To open the lid, raise it as far as it will go until the lid support bracket „locks" into the open
position.
•
To close the lid, lift it upward slightly until the lid support bracket „unlocks" and then gently
lower the lid.
TO AVOID DAMAGING THE CABINET OR THE LID, NEVER FORCE THE LID CLOSE.
ALWAYS RAISE THE LID TO RELEASE THE LID SUPPORT BRACKET.
PROTECT YOUR FURNITURE
This model is equipped with non-skid rubber „feet" to prevent the product from moving when you
operate the controls. These „feet" are made from non-migrating rubber material specially formu-
lated to avoid leaving any marks or stains on your furniture. However certain types of oilbased
furniture polished, wood preservatices, or cleaning sprays may cause the rubber „feet" to sof-
ten, and leave marks or rubber residue on the furniture. To prevent any damage to you furniture
we strongly recommend that you purchase small self-adhesive felt pads, available at hardware
stores and home improvement centres everywhere, and apply these pads to the bottom of the
rubber „feet" before you place the product on fine wooden furniture.
EN - 18
Advertisement
Table of Contents
