Jumping The Battery; Replacing The Fuse - Yamaha 2011 WaveRunner SuperJet Owner's/Operator's Manual

(2) Remove any weeds or debris from
around the jet intake, drive shaft, impel-
ler, jet pump housing, and jet thrust noz-
zle.
If debris is difficult to remove, consult a
Yamaha dealer.
EJU34641

Jumping the battery

If the watercraft battery has run down, the en-
gine can be started using a 12-volt booster
battery and jumper cables.
EJU34653
Connecting the jumper cables
EWJ01250
WARNING
To avoid battery explosion and serious
damage to the electrical system:
Do not reverse the polarity of the jumper
G
cables when connecting to the batteries.
Do not connect the negative (–) jumper
G
cable to the negative (–) terminal of the
watercraft battery.
Do not touch the positive (+) jumper ca-
G
ble to the negative (–) jumper cable.
(1) Connect the positive (+) jumper cable to
the positive (+) battery terminals of both
batteries.
(2) Connect one end of the negative (–)
jumper cable to the negative (–) battery
terminal of the booster battery.
Trouble recovery
(3) Connect the other end of the negative (–)
jumper cable to an unpainted bolt on the
cylinder head.
1 Positive (+) jumper cable
2 Booster battery
3 Negative (–) jumper cable
(4) Start the engine, and then disconnect the
jumper cables by reversing the steps
above. (See page 18 for information on
starting the engine.)
EJU34674

Replacing the fuse

If the fuse is blown, replace it with the proper
fuse.
1
1 Good fuse
2 Blown fuse
To replace the fuse:
(1) Remove the hood. (See page 23 for hood
removal and installation procedures.)
(2) Loosen the cap and remove it.
(3) Pull out the red lead to pull out the fuse
holder from the electrical box.
2
66