Troubleshooting - Kärcher CV 36/2 Manual

Replacing the brush strip
Unscrew the cover of the brush head.
Turn the brush in such a way that you
can push out the brush strip through the
opening or rather pull it out through the
opening.
Insert the new brush strip completely.
Screw on the cover.

Troubleshooting

The electronic system has switched
off the brush and suction motor.
Brush is blocked
Pull out the mains plug.
Check brush to see if there are impurities
and remove blocking objects, if any.
Turn on the appliance.
Suction turbine has switched off,
brush head is still functioning
Thermostat has switched off the motor
on account of over-heating
Pull out the mains plug.
Replace blocked filters or remove block-
ages from the suction hose.
The appliance is ready for use after ap-
prox. 20 minutes.
Suction hose is blocked
Turn off the appliance.
Remove the suction hose from the cas-
ing and straighten it.
14
English
Remove the blockage using a long ob-
ject.
If the blockage cannot still be removed, pro-
ceed as follows:
Press the locking lever and remove the
suction hose from the machine.
Rotate the suction hose at the threaded
part and remove it from the hand pipe.
Connecting hose is blocked
Remove the connecting hose by turning
both the ends.
Remove the blockage.